Filter
Top Products
66
67
19. There is no picture when using
MonitorLink/DVI input with an HDTV receiver
or DVD player.
• Make sure device is set to Output DVI in Device Menu.
• You may need to hook up to an analog input for initial setup.
• Power TV off. Unplug DVI cable from device and plug back in.
Power TV on first, then the DVI device.
20. No picture displays when using component
inputs.
• Make sure device is set to output at 480p or 1080i via YPbPr or RGB
(check device output for compatibility).
21. V-Chip is not working. • Make sure that V-Chip is active (page 43-45).
• If V-Chip Hours/Lock by Time is currently set to disable the
V-Chip lock, the V-Chip will not block programming.
22. Cannot set adjustments to factory setting. • Follow the steps below to reset system defaults to factory settings:
1. Press the MENU button followed by number buttons 1,2,and 3 on
the remote control.
Result: The Reset System Default menu screen is activated.
2. Press the ENTER button on the remote control.
Result: The settings reset to factory defaults.
3. Press HOME or MENU on the remote control to return to the HOME
or MENU screen.
IMPORTANT: This function is not recommended unless it is mandatory
to reset system defaults to factory settings. This operation CANNOT
be undone and all customs settings will be erased.
Troubleshooting, continued
LICENSOR’S SUPPLIERS DO NOT MAKE OR PASS ON TO END USER OR ANY OTHER THIRD PARTY,
ANY EXPRESS, IMPLIED OR STATUTORY WARRANTY OR REPRESENTATION ON BEHALF OF SUCH
SUPPLIERS, INCLUDING, BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF NON-INFRINGEMENT, TITLE,
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Digital Light Processing™ and DLP™ are trademarks of Texas Instruments.
MonitorLink™, ViewPoint®, QuickView™, SuperQuickView™ and PerfectColor™ are trademarks of Mitsubishi
Digital Electronics America, Inc.
Additional Information
WARNING: This product contains chemicals known to the State of California to cause cancer and/or birth defects or
other reproductive harm.