Filter
Top Products
PAGE 20 —V304 VIBRATORY ROLLER — OPERATION AND PARTS MANUAL — REV. #8 (11/13/09)
V304 — INSPECTION
Before Starting
1. Read safety instructions at the beginning of manual.
2. Clean the ROLLER, removing dirt and dust, particularly the
engine cooling air inlet, carburetor and air cleaner.
3. Check the air filter for dirt and dust. If air filter is dirty, replace
air filter with a new one as required.
4. Check carburetor for external dirt and dust. Clean with dry
compressed air.
5. Check fastening nuts and bolts for tightness.
Engine Oil Check
1. To check the engine oil level, place the saw on secure level
ground with the engine stopped, and the diamond blade
removed.
2. Remove the filler cap/dipstick from the engine oil filler hole
(Figure 10) and wipe it clean.
3. Insert and remove the dipstick without screwing it into the filler
neck. Check the oil level shown on the dipstick.
4. If the oil level is low (Figure 11), fill to the edge of the oil filler
hole with the recommended oil type (Table 3). Maximum oil
capacity is 400 cc.
Figure 10. Engine Oil Dipstick (Removal)
Figure 11. Engine Oil Dipstick (Oil Level)
NOTE
Some engines used with the V304 Roller
have an oil Alert System. This system will
automatically stop the in the event of low
oil level. ALWAYS be sure to check the
engine oil level prior to starting the engine.
Fuel
CAUTION :
NEVER fill the fuel tank (Figure 12) while
the engine is running or in the dark. Fuel
spillage on a hot engine can cause a fire
or explosion. If fuel spillage occurs, wipe
up the spilled fuel completely to prevent
fire hazards.
DO NOT smoke while refueling, motor
fuels are highly flammable and can be
dangerous if mishandled.
NOTE
Reference manufacturer engine manual for
specific servicing instructions.
epyTliO.3elbaT
nosaeS erutarepmeT epyTliO
remmuS rehgiHroC°52 03-W01EAS
llaF/gnirpS C°01~C°52 02/03-W01EAS
retniW rewoLroC°0 01-W01EAS