Filter
Top Products
V304 VIBRATORY ROLLER — OPERATION AND PARTS MANUAL — REV. #8 (11/13/09) — PAGE 9
■
High Temperatures – Always stop engine and allow the
engine to cool before adding fuel, oil or performing service
and maintenance functions. Contact with
hot
components can
cause serious burns.
■
NEVER engage the "
free wheel engagement leve
r" when
parked on an incline.
■
NEVER disconnect any
"emergency or safety devices"
.
These devices are intended for operator safety. Disconnection
of these devices can cause severe injury, bodily harm or even
death! Disconnection of any of these devices will void all
warranties.
Emergencies
■
ALWAYS know the location of the nearest
fire extinguisher
and
first aid kit
. Know the location of the nearest telephone.
Also know the phone numbers of the nearest
ambulance
,
doctor
and
fire department
. This information will be
invaluable in the case of an emergency.
Maintenance Safety
■
NEVER lubricate components or attempt service on a running
machine.
■
ALWAYS allow the machine a proper amount of time to cool
before servicing.
■
Keep the machinery in proper running condition.
■
Fix damage to the machine immediately and always replace
broken parts.
■
Dispose of hazardous waste properly. Examples of potentially
hazardous waste are used motor oil, fuel and fuel filters.
■
DO NOT use food or plastic containers to dispose of
hazardous waste.
■
DO NOT pour waste, oil or fuel directly onto the ground,
down a drain or into any water source.
Lifting
■
The roller has an operating weight of approximately 1,045
lbs. (474 Kg). Use lifting equipment capable of lifting this
weight.
■
ALWAYS check the roller's transport hooks. Make sure the
hooks are secure and tight before lifting the machine.
RULES FOR SAFE OPERATION
■
NEVER Run engine without air cleaner. Severe engine
damage may occur.
■
ALWAYS read, understand, and follow procedures in
Operator’s Manual before attempting to operate equipment.
■
ALWAYS be sure the operator is familiar with proper safety
precautions and operations techniques before using pump.
■
ALWAYS store equipment properly when it is not being used.
Equipment should be stored in a clean, dry location out of the
reach of children.
■
DO NOT operate this roller with hydrostatic oil temperature
higher than 180 degrees Fahrenheit.
■
NEVER leave the roller unattended, turn off engine and place
lock handle in upright position.
■
CAUTION must always be observed while servicing this roller.
Rotating parts can cause injury if contacted.
■
DO NOT leave roller with engine running. Use chock blocks
if parking roller on a grade.
■
NEVER ride on a walk-behind roller in unshored trenches or
near steep, unsupported banks. The vibration caused by the
roller could cause a cave-in.
■
ALWAYS use extreme care when walking behind the roller,
avoid having your feet or clothing getting caught under the
dolly wheels or roller.
■
Whenever possible try and stand to one side of the roller
rather than directly behind it.
■
ALWAYS use extreme care when operating near obstructions,
on slippery surfaces, grades and side slopes.
■
ALWAYS wear slip resistant safety shoes or boots.
■
Unauthorized equipment modifications will void all
warranties.
■
Uneven grades can cause the handle to
raise
or
lower
unexpectedly, striking the operator by surprise.
■
When working on slopes, avoid
sidehill travel
whenever
possible. Operate up and down travel only. Remember, the
danger of sliding on and/or tripping on steep slopes is always
present
■
NEVER ride on a walk-behind roller unless it is designed to
accommodate riders and an appropriate seat is provided.
■
Refer to the
Engine Owner's Manual
for engine technical
questions or information.