Filter
Top Products
V304 VIBRATORY ROLLER — OPERATION AND PARTS MANUAL — REV. #8 (11/13/09) — PAGE 23
V304 — INITIAL START-UP
Initial Start-up Instructions
Handle Bar Adjustment
Adjustment of the handle bar is made by removing the
handle bar
hitch pin
, then pulling the release pin. Once
released pin has been removed, position handle bar to
desired height (Figures 17 and 18), then insert release
pin and lock with cotter pin.
Starting
Figure 17. Handle Positions 1
Figure 18. Handle Positions 2
CAUTION:
DO NOT attempt to operate the roller until the
Safety, General Information and Inspection
sections have been read and understood.
Depending on the type of engine installed on
roller, operating steps may vary somewhat. See
engine manufactures operating manual. The
following start-up procedure makes reference
to a HONDA engine.
Figure 20. Engine Fuel Valve Lever
2. Place the engine
fuel valve lever
(Figure 20) to the "ON"
position.
Figure 19. Emergency Stop Button
1. ALWAYS make sure that the emer-
gency stop button (Figure 19) is
pulled all the way out (disengage).