Filter
Top Products
PAGE 26 —V304 VIBRATORY ROLLER — OPERATION AND PARTS MANUAL — REV. #8 (11/13/09)
V304 — OPERATION
Figure 30. Vibratory Control Lever (ON)
Shut-Down
1. Place the vibration control lever (Figure 31) on the roller to
the OFF position (vibration stops).
Figure 31. Vibratory Control Lever (OFF)
2. Place the water valve in the CLOSED position (if used).
3. Place the
engine throttle lever
(Figure 23) in the
slow
position, and let the engine idle for 3-5 minutes.
4. Place the
Engine ON/OFF switch
(Figure 32) in the "OFF"
position and remove the key. Place the key in a save place.
4. Place the engine
fuel valve lever
(Figure 20) in the OFF
position.
5. Clean the entire roller with warm water and mild soap. Pay
close attention to the scrapper bar and spray bar holes,
making sure that no dirt or debris is present. Dirt and debris
can cause the sprinkler system to get clogged.
Figure 32. Engine Ignition Switch (OFF Position)
CAUTION :
NEVER! engage vibrator on
concrete
or
asphalt
type surfaces.
Vibratory Control
1. For vibratory action, with the engine running (full speed)
place the vibratory control lever ( Figure 30) to the ON
position. The roller will now produce a vibratory frequency of
4,400 vps.