Filter
Top Products
I NTELLIP AD
®
Ci TOUCH S CREEN K EYPAD
25
Installing the TS-1 in New Construction
For a new construction site, use our optional New Construction Bracket (FG01060) to provide a
support for mounting the TS-1 on new drywall, as shown in Figure 14.
Figure 14
Using the optional New Construction Bracket (FG01060) to install a TS-1 in new construction.
continued on next page...
I NTELLIP AD
®
Ci TOUCH S CREEN K EYPAD
24
INSTALLATION CONSIDERATIONS (continued)
Installing the TS-1 in Existing Construction
1. At a proposed site, use the enclosed wall template to mark the outline of the TS-1. Check for
hidden obstructions by drilling a small hole in the drywall at the center of the outline. If you
feel any obstructions while drilling, stop immediately and select another site.
2. Bend a piece of stiff wire (e.g., coat hanger) about 6 inches from the end at a 90-degree angle.
Insert the bent end into the hole and rotate the wire to check if there are any other obstruc-
tions. If you hit anything, patch the hole with drywall compound and choose another site.
3. Connect the CAT-5 cable(s) to the TS-1’s rear jack(s) (see Connecting the TS-1 on page 27).
IMPORTANT: Test cable prior to connection, miswired and damaged cables can cause dam-
age to the TS-1.
4. The TS-1 is equipped with two Mounting Clamps for easy installation. Hold the TS-1 firmly in
the opening and use a Phillips screwdriver to turn each mounting-clamp screw to the right
until the TS-1 feels fastened, as shown in Figure 13.
NOTE: Do not overtighten the mounting-clamp screws.
Figure 13
Using the TS-1’s built-in mounting clamps.