Filter
Top Products
GB 16
Line on the Antenna Satellite Selection
Menu
One Antenna/One LNB Configuration
Select this alternative if you have one LNB mounted on the an-
tenna and you want to select another, not preprogrammed, sat-
ellite.
LNB Type
Select the local oscillator (L. O.) frequency valid for the present
LNB. The most common values, including Universal LNB, DiSEqC
U, and C band are selectable with the
buttons.
You can also enter a value with the numeric buttons when the
symbol for the remote control is visible on the line.
Satellite
Select one of the preprogrammed satellites.
This selection is necessary only if your satellite choice differs
from the preprogrammed satellite alternatives in the following
ways; if you do not use a universal LNB or when you have more
than two LNB’s.
Predefined Channel
Select one of the preprogrammed channels and adjust your an-
tenna according to the “Antenna Adjustment and Signal
Check” section on page 14.
OK
FIRST TIME INSTALLATION
7
Please follow the procedure de-
scribed on page 14.
OK
LNB Offset voltage
If the cable down from the antenna is very long, the voltage at
the LNB could be too low to change the polarization. You can in-
crease the voltage to the LNB by 0,5 V.
OK