Filter
Top Products
－１１１－
19. HARDWARE CHECK
19.2 Printer Check
This is for checking of trace printing with the cartridge pens and digital data printing with the plotter pen.
1 Example of Printing Check – When the time-axis synchronization (POC) is “off” in 3-pen type
2 Check Flow Chart
Operation screen
[Engineering mode selection]
(
+ )
3 sec. or more
[Selecting check]
[Selecting check items]
[Selecting printer]
[Displaying check]
[Executing check]
Digital data printing starts first.
→
Stop checking operation
1. Digital data printing (Plotter pen)
Two lines are printed. The number of
characters per line is 40 with AL and
72 with the AH (repetition of A to Z, 1
to 9 and 0).
2. Trace printing (Cartridge pens)
Each pen prints a sine curve.
(Note)
Even when the time-axis
synchronization is on, printing s
executed in condition of the time-axis
synchronization “off” during printing
check.
* is not accepted during
printing check.
For cancellation of printing check,
press and then press .
By pressing for 2 seconds or
more, the screen returns to the
operation screen, but the printing
disables. For changing the printing to
enable, press and then press
again.
See Reference 1 and Reference 2 in
section 19.1.
2 sec. or more
Cursor
Check
Cursor
∗
Types of engineering mode
and check 1
Check printing details
Cancellation of printing check
DISP
SHIFT
6
A - Z
°
C
°F
ENTRY
DISP
DISP
Cursor
Cursor
(1)
(2)
(3)
(4)
ENTRY
ENTRY
RE
C
ON/OFF
ENTRY
°C
°
F
RE
C
ON/OF
F
ENTRY
RE
C
ON/OFF
ENTRY
Reference
Reference