Filter
Top Products
11
Before Using the DV-SP404/DV-SP404E
Notes:
• If the remote controller doesn’t work reliably, try
replacing both batteries.
• Don’t mix new and old batteries, or different types of
batteries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage
and corrosion.
• Flat batteries should be removed as soon as possible to
prevent possible leakage and corrosion.
To use the remote controller, point it at the DV-SP404/
DV-SP404E’s remote control sensor, as shown below.
Notes:
• The remote controller may not work reliably if the
DV-SP404/DV-SP404E is subjected to bright light,
such as direct sunlight or inverter-type fluorescent
lights. Keep this in mind when installing the DV-
SP404/DV-SP404E.
• If another remote controller of the same type is used
in the same room, or the DV-SP404/DV-SP404E is
installed close to equipment that uses infrared rays,
the remote controller may not work reliably.
• Don’t put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
• The remote controller may not work reliably if the
DV-SP404/DV-SP404E is installed in a rack behind
colored glass doors. Keep this in mind when installing
the DV-SP404/DV-SP404E.
• The remote controller will not work if there’s an
obstacle between it and the DV-SP404/DV-SP404E’s
remote control sensor.
Installing the Batteries
1
Open the battery compartment, as shown.
2
Insert the two supplied batteries (AA) in
accordance with the polarity diagram
inside the battery compartment.
3
Close the battery compartment.
Using the Remote Controller
30˚
30˚
DV-SP404/DV-SP404E
Remote control sensor
Approx. 5 m
DV-SP404.404E_En.book Page 11 Wednesday, June 7, 2006 1:50 PM