Filter
Top Products
– 22 –
How to display the ≥VIDEO IN menu: ≥AUDIO IN menu: ≥AUDIO OUT menu:
menus:
≥AUDIO IN SET UP menu: ≥AUDIO IN PCM menu: ≥AUDIO IN CUE menu:
###
F7
AUDIO INF6AUDIO INF8AUDIO IN
AUDIO OUTAUDIO INVIDEO IN
Recording
Preparation
∑ Release the recording inhibit mode
≥Confirm that the REC INHIBIT lamp has gone out.
If the lamp has not gone out, set the positions of the cassette’s
accidental erasure prevention pins and the F13 (REC INH) set-
ting on the HOME menu to the recording enabled status.
∑ Selecting the input signals and adjusting their levels
≥Select the video input signal (INT SG or DIGITAL) on the VIDEO IN menu.
≥Select the audio input signal on the AUDIO IN PCM menu and the AUDIO IN CUE menu.
≥Adjust the audio input signal level on the AUDIO IN menu.
Adjust the audio input signal levels for the digital audio channels
CH1 to CH4 (or CH1-CH8 when the 8-channel format has been
selected) and for analog cue.
Normally, UNITY should be selected.
≥When adjusting the recording levels, select the channel whose
level is to be adjusted using the AUDIO IN menu (for example,
to adjust the PCM CH1 level, press the F1 key to set to white-
on-black display), and adjust the levels using the ADJUST con-
trol in such a way that 0 dB is not exceeded for the digital
signals and j20 dB is not exceeded for the analog cue signal.
≥The OVER display lights when the recording level is too high.
≥The level meter display can be switched.
The level meter display can be set to FULL or FINE using the F7
(SCALE) key on the AUDIO IN SET UP menu or the F7 (SCALE)
key on the AUDIO OUT SET UP menu.
REC INHIBIT
OVER