Filter
Top Products
– 45 –
Connector signals
∑ PARALLEL I/O (50P) connector
(1) PULSE SIGNAL: The signal fall is detected and the signal becomes active.
Pin no.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Signal
REC COMMAND
PLAY COMMAND
FF COMMAND
REW COMMAND
STOP COMMAND
STBY ON
COMMAND
STBY OFF
COMMAND
RS-422 REMOTE
ON COMMAND
RS-422 REMOTE
OFF COMMAND
LOCAL ENABLE
COMMAND
EJECT COMMAND
ENTRY
COMMAND
ALL_REC_INH_
ON COMMAND
PRE_CTL_INH_
ON COMMAND
LOCAL DISABLE
COMMAND
Direction
INPUT
INPUT
INPUT
INPUT
INPUT
INPUT
INPUT
INPUT
INPUT
INPUT
INPUT
INPUT
INPUT
INPUT
INPUT
Type
PULSE SIGNAL
PULSE SIGNAL
PULSE SIGNAL
PULSE SIGNAL
PULSE SIGNAL
PULSE SIGNAL
PULSE SIGNAL
PULSE SIGNAL
PULSE SIGNAL
PULSE SIGNAL
PULSE SIGNAL
PULSE SIGNAL
PULSE SIGNAL
PULSE SIGNAL
PULSE SIGNAL
Description
When this signal becomes active simultaneously with the
play command, it transfers the VTR to the REC PLAY
mode. However, the VTR is not transferred to the REC
mode if the insert or assemble mode has been set.
This transfers the VTR to the PLAY mode.
This transfers the VTR to the FF mode.
This transfers the VTR to the REW mode.
This transfers the VTR to the STOP mode.
When the VTR is in the loosing or STBY OFF mode, it is
set to the STNBY ON mode as soon as it receives this
command.
When the VTR is in the loosing or STBY ON mode, it is
set to the STNBY OFF mode as soon as it receives this
command.
This enables RS-422 control. However, the VTR must be
in the REMOTE mode for this command to take effect.
This disables RS-422 control.
This enables the REMOTE OP MAP functions. When the
MAP MODE is set to ALL, it also enables EJECT.
This transfers the VTR to the EJECT mode.
When this signal has become active, the VTR’s current
time (TC, CTL) is entered on the following menus:
When the VTR has opened the HOME menu:
≥The time is entered in CUE TIME on the HOME menu.
When the VTR has opened the AUTO EDIT menu:
≥The time is entered in CUE TIME on the HOME menu.
≥The time is entered at the IN point on the AUTO EDIT
menu.
When the VTR has opened the EXTEND MULTI CUE
menu:
≥The time is entered at the cursor position of the EXTEND
MULTI CUE menu.
When the VTR has opened the MULTI CUE menu:
≥The time is not entered on any of the menus.
When the VTR has opened a menu other than the ones
above:
≥The time is entered in CUE TIME on the HOME menu.
This selects ALL as the REC INH menu setting.
This selects PRE_CTL as the REC INH menu setting.
This disables the REMOTE OP MAP functions.
When the MAP MODE is set to ALL, it also disables
EJECT.