Filter
Top Products
– 27 –
USER menu <TIME CODE>
Setup menus (continued)
The underlined items indicates the initial setting.
No./Item Description
510
TC OUT REF
This is used to switch the phase of
the time code, which is output from
the TIME CODE OUT connector, for
the external LTC input when the
TCG switch is at the EXT position.
0000
V OUT :
Time code is synchronized with
output video signal.
0001 TC_IN :
Time code is synchronized with
external time code input.
511
VITC OUT
This selects how the VITC which is
to be superimposed onto the output
video signal is to be output.
0000
SBC :
During recording:
The input time code, which was
selected by the setup menu No.
505 (EXT TC SEL) setting and
TCG switch, is output as the
VITC.
During playback:
The time code recorded in the
SBC area is output as the VITC.
0001 VAUX :
During recording:
The time code detected from the
input video signal is output as the
VITC.
During playback:
The time code recorded in the
VAUX area is output as the
VITC.
Notes:
• The time code detected from the
input video signal is automatically
recorded in the VAUX area while
pictures are being recorded.
• If Y PB PR, CMPST, or SDI is
selected as the input signal, the VITC
output during recording is a timecode
superimposed on the input signal
regardless of the above setting.
514
VITC GEN
This selects whether or not to
record the internal time code
generator value in the VAUX area.
0000
OFF :
The internal time code generator
value is not recorded in the VAUX
area. When video signals on which
the time code has been recorded
are input, the time code of the input
signals is recorded in the VAUX
area.
0001 ON :
The internal time code generator
value is recorded in the VAUX area.
513
RUN MODE
This sets the operation mode which
is to make the internal time code
generator advance.
0000
REC :
The internal time code generator is
advanced during recording.
0001 FREE :
When the power is on, the internal
time code generator is advanced
regardless of the operation mode.
No./Item Description
SBC (sub code data) area:
This area is separate from the video and audio data area
on the helical track. The time code complying with
SMPTE/EBU standards is stored here. As with the
conventional LTC (linear time code), the time code can be
read even during rewinding or fast forwarding. It can also
be read out when the tape has stopped.
VAUX (video auxiliary data) area:
This area is to be found in the video data area on the
helical track.
The additional information relating to the video data is
stored here.
Note:
The time code and user bit are controlled during tape
playback by the data which has been recorded in the
SBC area. This means that all the data recorded in the
SBC area alone is used as the data which is to be
indicated on the counter display section in the middle of
the front panel or in the superimposed display, or as
the data which is to be transmitted to the editing
controller or other unit.
This appears only when the optional board
AJ-YA93P has been installed.
YA93P
YA93P