Filter
Top Products
– 39 –
Error messages (continued)
If “T&S&M” is selected in the setup menu No. 008 (DISPLAY SEL), a message appears in the modedisplay whenever a
warning or error occurs. When multiple events occur, the event with the highest priority is displayed.
Display Description
Priority
Error messages
(See error message table)
When an operational malfunction has occurred in the unit, the error number
flashes and the error message is indicated on the counter display.
INT SG
When SG has been selected as the input signal by the INPUT SELECT button, the
“INT SG” display will appear for the first two seconds at the start of operation (E-E
mode) when the REC button is pressed.
NO INPUT
If there are no input signals--with the exception of the analog audio signals--
supplied to the connectors selected by the INPUT SELECT button, the “NO
INPUT” display will appear for the first two seconds at the start of operation (E-E
mode) when the REC button is pressed.
Warning messages
(See error message table)
When a warning occurs in this unit, the error number and warning message are
indicated on the counter display.
When multiple warnings occur, the warning with the highest priority is displayed.
High
Low
Display Description
MATNO Material number
COPY Instance number (No. of copies)
OWNR Country, organization, user
DATE Date
TIME UTC (Coordinated Universal Time) and time difference with UTC
POS
Reception status from GPS satellites when recording spatial coordinates (height above sea
level, longitude and latitude):
HOLD : No reception from any satellite
2D : Reception possible, but number of satellites is insufficient. Height above sea level
will not be accurate.
3D : Good reception
UMID information display
This is displayed when UMID information is present on the input signal in E-E mode.
This lamp lights during tape playback when UMID information has been recorded on the tape. “NO-INFO” is displayed
when there is no UMID information.