Filter
Top Products
ENGLISH
27 (E)
Recording
1
Set the accidental erasure prevention tab on the cassette tape to the “recording”
position and insert the tape.
2
Press the STOP button to place the unit in the stop mode.
3
Set the TAPE/EE switch to EE.
EE images now appear on the TV monitor.
4
Check that the REC INHIBIT lamp is off.
If this lamp is lit, set the REC INHIBIT switch to OFF.
5
Select the video and audio input signals and adjust their levels.
5-1 Selecting video/audio input signals
1 Connect the signals to be recorded.
2 Select the input signals using the INPUT SELECT switches on the front panel.
The input signals corresponding to the lit lamps have been selected.
5-2 Adjusting the video level
[When the analogue video input board (optional accessory) has been installed]
1 Normally, the VIDEO IN LEVEL control/switch %0 is left at the “PRESET”
setting (unity value).
2 To adjust the recording level, set the VIDEO IN LEVEL control/switch %0 to
“MANUAL” and use it to adjust the level to a setting between +3 dB and –3 dB.
5-3 Adjusting the audio level
1 Adjust the audio input signal levels of the analogue audio CH1/CH2, CH3/CH4
signals and analogue cue signal. Keep the audio input/output level controls $5
pushed in (unity value).
The audio signals will be recorded at the proper level.
2 To adjust the recording level, pull out the controls $5 and adjust them. With the
CUE signal, adjust the control in such a way that –20 dB will not be exceeded.
6
Press the PLAY button while holding down the REC button. The REC and PLAY lamps
light, and recording commences.
7
To end the recording, press the STOP button.
Recording is ended, and the unit goes into the stop mode.
<Notes>
• Check that the SERVO lamp is lit during recording. If it flashes or if it is off, the images
played back will be disturbed.
• Only the analogue composite video input signals can be adjusted. (The digital video and
analogue component input signals cannot be adjusted.)