Panasonic AJ-D960EG VCR User Manual


 
Automatic editing
36 (E)
POWER
ON
OFF
L
LEVEL CH4 CUE
DVCPRO
AUDIO ANALOG
VIDEO Y PB PR
AES/EBU USER SET
CMPST
INPUT SELECT
SDI
CH CONDITION
SCH CF
SHIFT ADJ START RESET
STAND BY
UB EXT EE
TC INT
TC MODE
TAPE
LOCAL
REV FWD
PULL
OPEN
JOG
PUSH
EJECT
AUTO OFF
SHTL
SLOW
CONTROL
REMOTE
EDIT
REW
PLAY
SERVO
STOP
PLAYER
REC
REC INHIBIT
FF
RECORDER
TC/CTL
TC SET
INSERT
CH2
TRIM
SET OUTIN
CH3 CH4 CUE TC
AUTO EDIT
PREROLL
PREVIEW
REVIEW
REC
PB
PULL FOR VARIABLE
PULL
OPEN
HEADPHONES
CH1 CH2
R
METER
FULL/FINE
MONITOR SELECT
W
–+
SDI
SDTI(V&A)
ASMBL
VIDEO CH1
4567321
A
OUT
A
IN
MULTI CUE
CH3
8
SLOW MOTION
2 1, 3
Checking the edit points
1
Press the IN (or OUT) button to check the edit point.
The value of the entered edit point appears on the display.
2
Press the PREROLL button while holding down the IN (or OUT) button to check the
image at the edit point.
The tape is cued at the edit IN (or OUT) point, and the still picture mode at that point is
displayed.
• The EE mode is established if the TAPE/EE switch has been set to the “EE” position
when “STOP” has been selected for the setup menu No. 315 (AFTER CUE-UP).
3
Continue to hold the IN and OUT buttons down together, and check the edit section
(duration time).
The duration time appears on the display.
Calculating the duration
• When both edit points have been set, the duration between the two edit points.
• When only one edit point has been set, the duration between the set data and the current
tape address.
• When neither edit point has been set, the duration of the previously edited interval.