Filter
Top Products
41
RQT9338
Reference
IP address is not set. ≥The “IP Address” in “IP Address / DNS Settings” is “---. ---. ---. ---”. Set the “IP Address”,
“Subnet Mask”, and “Gateway Address”. (Select the automatic address acquisition if
necessary.) (> 29)
Cannot obtain IP address.
Please check the connection or
setting of the router.
≥If you use a hub, then check the connection between the hub and the router.
j Use the UPLINK port of the hub to connect to a router. (> 28)
j Check whether or not the hub’s Link lamp lights up. If it does not light up, then check the
cable connection, LAN terminal connection, cable itself (a crossover cable may have been
used by mistake), etc.
≥If the above conditions are OK, then the router may not operate in DHCP mode. Check the
router settings and operation. You may reset the router to restore it to normal. (> 29)
This IP address is already in
use.
Please check the setting.
≥This unit’s IP address is used by another device. Check the IP addresses of this unit,
personal computers, and routers, etc. If necessary, reconfigure them to avoid IP addresses
from being duplicated.
Connection test could not be
conducted.
IP address is not set correctly.
≥Turn the unit off. Disconnect the power source (the AC adaptor or battery pack) and
reconnect it and try again. If the same symptom persists, then consult your dealer.
Connection test was
unsuccessful. No reply
from Gateway. Please check
the connection or
setting of the router.
≥If you use a hub, then check the connection between the hub and the router. (> 28)
j Use the UPLINK port of the hub to connect to a router.
j If the hub’s Link lamp does not light up, then check the cable connection, LAN terminal
connection, cable itself (a crossover cable may have been used by mistake), etc.
≥Check the “IP Address”, “Subnet Mask”, and “Gateway Address” in the “IP Address / DNS
Settings”. (> 29)
≥If the MAC address information is required, then press [SETUP] to display the “Network
Settings” menu. (> 28)
Network connection was
rejected.
Please confirm Setup "BD-Live
Internet Access".
≥When you set “BD-Live Internet Access” to “Limit” and play BD-Live contents which do not
have a content owner certificate, the Internet access of the content is not allowed. If you
allow the content to connect to Internet, set “BD-Live Internet Access” to “Permit”. (> 32)
Could not check for latest
firmware version.
Please try again later.
≥The firmware download server is currently unavailable. Please try again later.
DMPB15EB-RQT9338_eng.book 41 ページ ２００９年３月２７日 金曜日 午後１０時１３分