Filter
Top Products
VQT2J81
(ENG)
32
Precautions of Wireless LAN Adaptor
The following limits are in place regarding the usage of this
device. You must be aware of these limits before using this
device.
Panasonic will in no way be responsible for any incidental
damage which may arise due to a failure to obey these limits,
or to any condition of use or disuse of this device.
≥ Do not use this device to connect to any wireless
network for which you do not have usage rights.
During automatic searches in a wireless network
environment, wireless networks (SSID*) for which you do not
have usage rights may be displayed; however, using these
networks may be regarded as illegal access.
*An SSID (Service Set IDentification) is a name used by
wireless LAN to identify a particular network. Transmission
is possible if the SSID matches for both devices.
≥ Data transmitted and received over radio waves may be
intercepted and monitored.
≥ This wireless LAN adaptor contains delicate electronic
components.
Please use this adaptor in the manner in which it was
intended and follow the following points:
jDo not expose the adaptor to high temperatures or direct
sunlight.
jDo not bend, or subject the adaptor to strong impacts.
jKeep the adaptor away from moisture.
jDo not disassemble or alter the adaptor in any way.
jDo not attempt to install the adaptor in any incompatible
device.
Network Easy Setting
Setting for when this unit is used connected to a network.
≥ After completing “Easy Setting” (> 11), you can continuously
perform “Network Easy Setting”. (B Go to step 4)
Preparation
Connect to a broadband network. (> 31)
1 Press [SETUP].
2 Press [3, 4] to select “Network” and press
[OK].
3 Press [3, 4] to select “Network Easy
Setting” and press [OK].
4 Select “Wired” or “Wireless” and press
[OK].
≥ Supplied Wireless LAN Adaptor and DY-WL10 are
equivalent to each other.
If “Wireless LAN Adaptor is not connected.” is displayed,
check that the Wireless LAN Adaptor is fully inserted.
Alternatively, disconnect and reconnect it. If there is still no
change in the display, consult your dealer.
5 Follow the on-screen instructions and make
the settings with [3, 4, 2, 1] and press
[OK].
For wireless LAN connection:
If you are using a Wireless router (Access point) that supports
WPS, you can easily perform the settings by selecting “WPS
(PUSH button method)”.
Otherwise, perform the settings by selecting “Search for
access point” or “Manual setting” in “Other methods”.
≥ WPS (Wi-Fi Protected Setup) is a function that facilitates
settings relating to the connection and security of wireless
LAN devices. To see whether your Wireless router (Access
point) supports WPS, check the Wireless router operating
instructions.
OK
RETURN
Network Easy Setting (Connection Test)
Wired
Wireless
Select a connection mode.
Current setting : Wired
LAN cable connection:
Connect a LAN cable to the unit and select "Wired."
Wireless LAN connection:
Connect the Wireless LAN Adaptor (DY-WL10) to the USB
port and select "Wireless."
OK
RETURN
Access Point Connection Setting
Select a connection method to use with an access point
of Wireless LAN.
Please refer to the operating instructions of the access
point about connection methods.
WPS (PUSH button method)
Other methods
p
WPS (PIN code method)
Search for access point
Manual setting
DMPB500PP-VQT2J81_eng.book 32 ページ ２０１０年３月１６日 火曜日 午後４時８分