Filter
Top Products
Reference
VQT2J81
(ENG)
47
The unit is on but cannot be operated.
¾Is the incorrect playback media or operation function
selected?
¾The unit may not be operating properly due to lightning, static
electricity or some other external factor. Turn the unit off and
then back to ON. Alternatively, turn the unit off, disconnect
the power source (AC or battery pack), and then reconnect it.
¾Condensation has formed. Wait 1 to 2 hours for it to
evaporate.
Play fails to start even when [1] (PLAY) is pressed.
Play starts but then stops immediately.
¾Insert the media correctly with the label facing up. (> 13)
¾The media is dirty. (> 5)
¾You tried to play a blank media or unplayable media on this
unit. (> 6)
¾[DivX]: If playing DivX VOD content, refer to the homepage
where you purchased it. (> 24)
No response when remote control buttons pressed.
¾Check that the battery is installed correctly. (> 9)
¾The battery is depleted: Replace it with new one. (> 9)
¾Point the remote control at the remote control sensor and
operate. (> 9)
Start up is slow.
It takes time before play starts.
¾Make sure that “Quick Start” is set to “On”. (> 40)
¾Start up takes time in the following situations.
jImmediately after a power failure or the AC adaptor is
connected.
jWhen the unit is connected with an HDMI cable.
Played back image is distorted or does not play
back correctly. (
[AVCHD])
¾High-definition video (transfer rate of 18 Mbps or faster)
cannot be played back correctly if it was recorded on a DVD
compatible to double speed or slower.
Cannot set “On” in “24p Output”.
¾Only when this unit is connected to a TV supporting 24p
output via an HDMI cable, you can set to “On”. (> 38)
Buttons do not work.
¾Touch the operation panel (> 8) lightly with a finger. It may
not respond when pressing with the tip of finger nail or with a
gloved finger.
No picture on the LCD.
¾Check connections. (> 10)
¾Select “On” in “Monitor”. (> 12)
¾[DivX]: Images may not be output due to how files were
created. (> 42)
The LCD is dark.
¾Select the appropriate Picture Quality mode. (> 12)
LCD pixels turn black or radiate different colors.
¾The LCD is constructed with precision technology so
99.99 % of the pixels are active, but of the remaining of
0.01 %, there are pixels that may be black or emit light
constantly. This phenomenon is not a malfunction.
Picture is distorted.
¾The quality of video will lower on the screen of this unit when
HDMI is connected. (> 28)
There is a lot of after-image when playing video.
¾Turn “3D NR” or “Integrated NR” off if it is on. (> 27)
A black band is displayed around the edge of the
screen.
The aspect ratio of the screen is abnormal.
¾Confirm the “TV Aspect” is set properly. (> 38)
Still pictures (JPEG) do not play back normally.
¾The images that were edited on the PC, such as Progressive
JPEG, etc., may not play back. (> 42)
Operation LCD
DMPB500PP-VQT2J81_eng.book 47 ページ ２０１０年３月１６日 火曜日 午後４時８分