Filter
Top Products
VQT4J81
36
36
8
Press and hold [REC *]
for 1 second or more.
The unit enters the recording
standby.
Blinks
9
Play back the external device and adjust the
input/output level.
1
If the level meter swings and “ ” is displayed,
the volume of the external device is too high.
Adjust the volume of the external device to the
“
” range, even if the volume is turned to the
maximum.
To reconfigure the line input settings, press
[MENU] and follow steps
4
to
6
.
2
After you finish adjusting the input/output level,
stop the sound source of the other device at the
position where you want to start recording.
10
Press [REC *] to start recording.
11
Play the external device.
*
Read the operating instructions for the connected device.
* Disconnecting the audio cord during recording will
stop recording.
* Change the line recording mode as necessary.
(➜ page
37)
* The L folder will be automatically selected for
recording when line input sound is recorded.
Recording from other devices
This unit has the following synchro recording function.
This function detects the silence between tracks, etc.
and then records each track into different files, such as a
first track, second track, etc. If detecting sound from the
external device, recording starts automatically. If detecting
silence for approx. 2 seconds or more, recording is
paused. Detecting sound again will resume recording.
Synchro recording setting
•
Press [
STOP g
/RETURN] to stop the unit.
1
Press [MENU].
2
Press +, – to select “LINE REC” and press
[q OK] to enter.
3
Press +, – to select “SYNCHRO REC” and
press [q OK] to enter.
4
Press +, – to select “ON
(Auto Stop)” or “ON
(Manual Stop)” and press
[q OK] to enter.
Auto: The recording pauses if approx. 2 seconds or
more of silence is detected and stops if silence
continues approx. 15 seconds or more.
Manual: Even if silence continues, the recording
continues to be paused (standby) until
[STOP g/RETURN] is pressed.
(The factory setting is “OFF”.)