Filter
Top Products
24
RQTV0238
LANG - 5 LANG - 4 FRANÇAIS DANSK
The buttons described for “Using the microphone” are
mainly for the main unit unless indicated otherwise.
Enjoying the microphone mixing
Enjoying the microphone mixing
You can enjoy microphone mixing from various music
sources (cassette, disc, radio or other equipment
connected to this unit).
1
Firstly, lower the volume with [- MIC VOL+], then
connect the microphone(s) to the microphone
jack(s).
Every time you press the button:
MIC 1 ↔ MIC 2 ↔ MIC 3 ↔ MIC 4
Use a dynamic microphone.
Plug type : Ø6.3 mm monaural
2
Start playing the music source.
3
Adjust the volume with
[- VOLUME+]
and
[- MIC VOL+]
and sing along.
Note:
• If a strange noise (howling) is emitted during use, move
the microphone away from the speakers, or turn down the
microphone volume.
• When you are not using the microphone, disconnect it from
the microphone jack, and turn down the microphone volume
level to “MIC 1”.
• Sound adjustments can be made using microphone mixing
but recording will not be affected.
Record microphone mixing
Record microphone mixing
1
Press [OPEN, ] for DECK 2 and insert the
cassette to be recorded.
Insert with the side to be recorded facing towards
you and the exposed tape facing down.
2
Lower the volume with [- MIC VOL+], then
connect the microphone(s) to the microphone
jack(s).
3
Select the music source:
• When singing along with discs
Insert the desired disc ( page 10).
• When singing along with cassette
Insert the desired cassette into DECK 1
( page 22).
This is applicable only during stop mode.
• When singing along with radio
Select your desired station ( page 22).
• When singing along from the other equipment
Connect and prepare the other equipment
( page 27).
4
Press [ , RECORD] and start microphone mixing.
To record your voice
To record your voice
1
Press [OPEN, ] for DECK 2 and insert the
cassette to be recorded.
Ensure that there is no tape in DECK 1.
2
Lower the volume with [- MIC VOL+] then
connect the microphone(s) to the microphone
jack(s).
3
Press [ , RECORD] to start recording.
4
Speak through the microphone and adjust the
volume with [- VOLUME+] and [- MIC VOL+].
Using the microphone
For Southeast Asia only
A.SRND
–
ECHO
Adjusting the echo effect
Adjusting the echo effect
1
Lower the volume with [- MIC VOL+] then
connect the microphone(s) to the microphone
jack(s).
2
Press and hold [–ECHO].
Current setting appears on the display.
3
While the current setting is displayed
Press and hold [–ECHO] to change the setting.
Every time you press and hold the button:
ECHO 1 ECHO 2 ECHO 3
ECHO OFF (off)
ECHO 4
Note:
• The effect increases with the level.
• The setting will change only if you press and hold [–ECHO]
right after the current setting is displayed.
SC-VK660_EN(GCS).indd 24SC-VK660_EN(GCS).indd 24 5/4/07 12:00:03 AM5/4/07 12:00:03 AM