Filter
Top Products
26
RQTV0238
LANG - 5 LANG - 4 FRANÇAIS DANSK
Using the timers
-
CLOCK
/
TIMER
–DIMMER
Setting the time
Setting the time
This is a 24-hour clock.
1
Press [- CLOCK / TIMER] to select “CLOCK”.
Every time you press the button:
CLOCK
˚ PLAY
Original display
˚ REC
2
(
Within 7 seconds or so
)
Press [4, / REW] or [¢, / FF] to set the
time.
3
Press [- CLOCK / TIMER] to finish setting the time.
To display the time
Press [- CLOCK / TIMER] once when the unit is on or in
standby mode.
The time is displayed for a few seconds.
Note:
Reset the clock regularly to maintain accuracy.
–
FL DISPLAY
PLAY
/
REC
Using the play or record timer
Using the play or record timer
You can set the timer to come on at a certain time to
wake you up (play timer) or to record from the radio or
the external equipment (record timer).
Play timer and record timer cannot be used together.
Turn the unit on and set the clock.
• For the play timer, prepare the desired music
source; cassette (DECK 2 has the priority), disc
number (1 ~ 5), radio or other external equipment,
and set the volume.
• For the record timer, check the cassette’s erasure
prevention tabs (\ page 23) and insert the tape in
DECK 2 (\ page 23) and tune to the radio station
(\ page 22) or select the external equipment
(\ page 27).
1
Press [- CLOCK/TIMER] to select the timer function.
Every time you press the button:
CLOCK
˚ PLAY
Original display
˚ REC
˚PLAY : to set the play timer
˚REC : to set the record timer
(Proceed to the next step
within 7 seconds
)
2
(
Within 7 seconds or so
)
Press [4, / REW] or [¢, / FF] to set the
“ON” time.
3
Press [
-
CLOCK / TIMER] to confirm.
4
Repeat steps 2 to 3 to set the “OFF” time.
To activate the timer
5
Press [ ˚PLAY/REC] to display the timer’s
indicator.
Every time you press the button:
˚ PLAY
(off)
˚ REC
˚PLAY : to turn the play timer on
˚REC : to turn the record timer on
(The indicator does not appear if the start and
fi nish times or the clock has not been set.)
6
Press [y] to turn off the unit.
The unit must be off for the timers to operate.
To change the settings
Perform steps 1 to 4 and 6 (\ see left).
To change the source or volume
When the unit is on
1
Press [
˚
PLAY/REC] to clear the timer indicator
from the display.
2
Make changes to the source or volume.
3
Perform steps 5 and 6 (\ see left).
To check the settings
Press [
-
CLOCK / TIMER] while the unit is on to select
˚PLAY or ˚REC.
The setting are shown in the following order.
– Play timer: start time
fi n i s h t i m e
source
volume
– Record timer: start time
fi n i s h t i m e
source
When the unit is off
1
Press [
-
CLOCK / TIMER].
2
During the clock display, press [
-
CLOCK / TIMER]
again.
To cancel the timer
Press [ ˚PLAY/REC] to clear the timer indicator from
the display.
(The timer comes on at the set time everyday if the timer
is on)
If you use the unit after the timers are set
After using, check that the correct tape or disc are
loaded before turning the unit off.
Note:
• The play timer will start at the preset time with volume
increasing gradually to preset level.
• The record timer will start 30 seconds before the set time
with the volume muted.
• The timer comes on at the set time every day if the timer is
on.
• The unit must be in the standby mode for the timer to
function.
• If you turn the unit off and on again while a timer is
functioning, the fi nish time setting will not be activated.
• If MUSIC PORT is selected as the source when the timer
comes on, the system turns on and engages MUSIC PORT
as the source. If you wish to playback or record from the
portable audio equipment, just activate the equipment’s play
mode and increase the volume. (See the portable audio
equipment’s instruction manual.)
SC-VK660_EN(GCS).indd 26SC-VK660_EN(GCS).indd 26 5/4/07 12:00:06 AM5/4/07 12:00:06 AM