Filter
Top Products
6
RQTV0238
LANG - 5 LANG - 4 FRANÇAIS DANSK
Simple setup (continued)
Placement of speakers
Placement of speakers
Subwoofer
Front speaker
(right)
Front speaker
(left)
Main
unit
Place the
subwoofer on the
fl oor or a sturdy
shelf so that it will
not cause vibration.
Front speakers
Speakers are designed identically so that no left or right
channel orientation is necessary.
You cannot take the front net off the speakers.
Use only the supplied speakers
• The combination of the main unit and speakers provide
the best sound. Using other speakers can damage the
unit and sound quality will be negatively affected.
• Set the speakers up on an even surface to prevent them
from falling. Take proper precautions to prevent the
speakers from falling if you cannot set them up on an
even surface.
Positioning for best effect
How you set up your speakers can affect the bass and the
sound fi eld. Note the following points.
• Place speakers on fl at secure bases.
• Placing speakers too close to fl oors, walls, and corners
can result in excessive bass. Cover walls and windows
with a thick curtain.
If irregular coloring occurs on your television
These speakers are designed to be used close to a
television, but the picture may be affected with some
televisions and set-up combinations.
If this occurs, turn the television off for about 30
minutes.
The television’s demagnetizing function should correct the
problem. If it persists, move the speakers further away from
the television.
Note:
• Keep your speakers at least 10mm away from the system
for proper ventilation.
• You can damage your speakers and shorten their
useful life if you play sound at high levels over extended
periods.
• Reduce the volume in the following cases to avoid
damage.
− When playing distorted sound.
− When the speakers emit strange noise (howling)
from a microphone or record player, noise from FM
broadcasts, or continuous signals from an oscillator,
test disc, or electronic instrument.
− When adjusting the sound quality.
− When turning the unit on or off.
Caution
•
Use the speakers only with the recommended
system. Failure to do so can damage the amplifi er
and speakers, and can cause fi re. Consult a
qualifi ed service person if damage occurs or if a
sudden change in performance is apparent.
• Do not attach these speakers to walls or ceilings.
Preparing the remote control
R6/LR6, AA
Insert so the
poles (+ and –)
match those in the
remote control.
• Do not use
rechargeable
type batteries.
Do not:
• mix old and new batteries.
• use different types of the batteries at the same time.
• heat or expose batteries to fl ame.
• take apart or short circuit the batteries.
• attempt to recharge alkaline or manganese batteries.
• use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage
which can severely damage the remote control.
Remove the batteries if the remote control is not going to be
used for a long period of time. Store in a cool, dark place.
■ Use
Aim at the remote control signal sensor (\ page 8),
avoiding obstacles, at a maximum range of 7 m directly in
front of the unit.
DEMO function
DISPLAY, -DEMO
When the unit is fi rst plugged in, a demonstration of its functions may be
shown on the display.
If the demo setting is off, you can show a demonstration by selecting “DEMO
ON”.
Press and hold [DISPLAY, -DEMO].
The display changes each time the button is held down.
DEMO OFF DEMO ON
While in standby mode, select “DEMO OFF” to reduce power consumption.
Note:
When the DEMO function is on, the Dimmer switches off automatically.
SC-VK660_EN(GCS).indd 6SC-VK660_EN(GCS).indd 6 5/3/07 11:56:00 PM5/3/07 11:56:00 PM