Filter
Top Products
28
RQTV0238
LANG - 5 LANG - 4 FRANÇAIS DANSK
Using other equipment (continued)
Changing the main unit and remote
Changing the main unit and remote
control mode
control mode
The remote control and main unit are factory-set to
“REMOTE 1” mode.
If your remote control affects other equipment during
operation, you can switch to operate in “REMOTE 2”
mode.
To switch to “REMOTE 2” mode
1
While pressing and holding [EXT-IN] on the main
unit
Press and hold [2] until “REMOTE 2” appears on
the main unit display.
2
Press and hold [ENTER] and [2] for at least 2
seconds.
The main unit and remote control are now set to
operate in “REMOTE 2” mode.
To return to “REMOTE 1” mode
Perform steps 1 and 2 but use [1] instead of [2] for both
steps. (“REMOTE 1” appears on the main unit during
step 1.)
The remote control cannot work with the main unit if
their modes are different.
“REMOTE 1” or “REMOTE 2” appears on the main unit
display when you operate the remote control.
If “REMOTE 1” appears (The main unit is in
“REMOTE 1” mode.)
Press and hold [ENTER] and [1] on the remote
control for at least 2 seconds.
If “REMOTE 2” appears (The main unit is in
“REMOTE 2” mode.)
Press and hold [ENTER] and [2] on the remote
control for at least 2 seconds.
Note:
You can still operate a television using the remote control
( see left) even after switching the mode.
Operating a television
Operating a television
Point the remote control at the television for the
following operations.
To switch the television on or off
To switch the television’s video input mode
TV/AV
Adjust the volume
VOLUME
Note:
Some models cannot be operated by this remote control.
Connecting to other external unit
Connecting to other external unit
You can connect to an analog player with a built-in
phone equalizer.
(R)
(L)
“LINE OUT”
position
L
R
AUX IN
Analog player
(not included)
Rear panel of this unit
Playing or recording from other
Playing or recording from other
external unit
external unit
1
Press [EXT-IN] repeatedly until “AUX” is displayed.
MUSIC PORT AUX
2
For listening : Proceed to step 3.
For recording : Press [¶, RECORD] on the main
unit to start recording.
3
Start playback from the external source.
Note:
• For details, refer to the instruction manual of the unit which
is to be connected.
• When units other than those described above are to be
connected, please consult your audio dealer.
• Sound distortion may occur when you use an adaptor other
than the one supplied.
SC-VK660_EN(GCS).indd 28SC-VK660_EN(GCS).indd 28 5/4/07 12:00:56 AM5/4/07 12:00:56 AM