Filter
Top Products
21
ERROR1
(2) Upload Setting
1. Display the PRESET DATA LOAD menu.
2. Select a camera number between CAM1 and CAM8 by
moving the joystick up or down.
3. Press the PRESET/SET/PROGRAM PRESET button.
4. The camera number and upload menu appear on the
monitor as shown below.
5. Select UP LOAD by moving the joystick up or down.
6. Press the PRESET/SET/PROGRAM PRESET button.
Uploading starts.
CAM1:
DOWN LOAD
UP LOAD
DATA TITLE
END
LOADING Blinking
7. While uploading, the word LOADING appears on the
right.
■ changing to
P
in the progress bar indicates the
progress of uploading.
8. When uploading is completed, END appears on the
right. The progress bar disappears.
Notes:
• The preset data of up to 8 cameras can be uploaded.
• Uploading time is approx. 2 minutes per camera. When
uploading is completed, the combination camera such
as WV-CS854, WV-CS654 or WV-CS604 will move to the
Preset Position.
• Upload only preset data.
Make any other settings from the Camera Setup menu.
• The camera picture may change as a result of upload-
ing data. Access the Camera Setup menu to make the
necessary settings.
• Any previous preset data is overwritten by the uploaded
data.
• To terminate uploading, press the HOME/ESC button
while uploading. ERROR 3 appears. The progress bar
disappears.
• END and error messages remain on the menu until the
next operation is performed.
Message Cause Note
Incompatibility
Incompatibility detected
between transmission
data and camera model
while uploading.
ERROR 3 Causes except
above
Uploading not possible
for some reason other
than the above.
CAM1:
DOWN LOAD
UP LOAD
DATA TITLE
• In case of RS-485 Site Communication mode, check
that the unit address is the same as set on the combi-
nation camera. If the numbers do not agree, the camera
cannot be operated.
Therefore, preset data cannot be uploaded.
• Error Display
When an error occurs during uploading, the following
messages appear on the monitor.
(3) Data Title Setting
1. Display the PRESET DATA LOAD menu.
2. Select the desired CAM1-CAM8 position by moving the
joystick up or down.
3. Press the PRESET/SET/PROGRAM PRESET button.
4. The camera number and data title menu appear on the
monitor as shown below.
CAM1:
DOWN LOAD
UP LOAD
DATA TITLE
5. Select DATA TITLE by moving the joystick up or down.
The DATA TITLE menu appears as shown below.
CAM1:
0123456789
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
().,’”:;&#!?=
+-*/%$
SPACE
Selected Character
Area
Character Area
Space
6. Move the cursor to the desired character in the charac-
ter area by moving the joystick upward, downward,
right or left.
7. Press the PRESET/SET/PROGRAM PRESET button.
8. Repeat procedure 6 to 7 until all characters are edited.
Up to 12 characters can be selected.