Filter
Top Products
4848
Using Network Function
PJLink™ Protocol
The network function of the unit conforms with PJLink™ class 1 and you can operate the following actions from your
computer using PJLink™ protocol.
• Display setup
• Display status query
Supported commands
Commands to control the unit with PJLink™ protocol are shown in the table below.
PJLink™ security authentication
Set “panasonic” for the PJLink™ password.
• PJLink™ is a pending trademark in Japan, the United States, and other countries or areas.
Command Control Remark
POWR Power control
Parameter
0 = Standby 1 = Power “On”
POWR ? Power status query
Parameter
0 = Standby 1 = Power “On”
INPT Input switch
Parameter
See the parameter for command INST ?
INPT ? Input switch query
AVMT Shutter control Parameter
10 = Picture On (picture mute deactivated), 11 = Picture Off (picture on mute)
20 = Audio On (audio mute deactivated), 21 = Audio Off (audio on mute)
30 = Shutter mode Off (picture and audio mute deactivated)
31 = Shutter mode On (picture and audio on mute)
AVMT ? Shutter control query Parameter
11 = Picture Off (picture on mute)
21 = Audio Off (audio on mute)
30 = Shutter mode Off (picture and audio mute deactivated)
31 = Shutter mode On (picture and audio on mute)
ERST ? Error status query Parameter
First byte: 0
Second byte: 0
Third byte: 0
Fourth byte: 0
Fifth byte: 0
Sixth byte: Means other error. 0 or 2.
Meaning of the 0 – 2 settings:
0 = Error is not detected, 2 = Error
LAMP ? Lamp status query Not supported
INST ? Input switch list query
Parameter
11: PC IN input (PC)
32: HDMI2 input (HDMI2)
31: HDMI1 input (HDMI1)
32: DVI-D IN input (DVI)
NAME ? Projector name query Return the Display name contents selected in “Network Setup”.
INF1 ? Manufacturer name query Returns “Panasonic”
INF2 ? Model name query Returns “65LFE7U”/“65LFE7E” (for 65-inch model)
INFO ? Other information query Returns version number
CLSS ? Class information query Returns “1”
Command Control
Network function of the unit can control the unit in the same way as serial control from a network.
Supported commands
Commands used in the serial control are supported. (see page 12)
Note:
Consult your local Panasonic dealer for detail instructions on command usage.