Filter
Top Products
46 Pelco Manual C673M (2/01)
RECORDING AFTER A POWER FAILURE
After a power failure during manual, timer, or alarm recording, the VCR turns itself on when
the power is restored and begins recording in the same mode as before the failure.
When power is restored, an “X” appears next to the present time on the screen for about a
minute. The fluorescent display shows the power loss indicator (PL).
If there is a power failure during playback, the VCR will be in stop mode when power is
restored.
Refer to the
Power Loss List
section for more information on viewing and clearing the list.
MAINTENANCE
POWER LOSS LIST
00476
01-01-'97 WED
00:00:00 X L24
00477
<MAINTENANCE>
POWER LOSS LIST
ALARM LIST
ALL MENU INITIALIZE
POWER LOSS LIST CLEAR
ALARM LIST CLEAR
<REPEAT REC TIMES> 0
<ELAPSED TIME> 0H
00478
<POWER LOSS LIST>
01 01-31-’00
00:00
02
00479
POWER LOSS LIST CLEAR
Turn the SHUTTLE RING
then POWER LOSS LIST
will be cleared.
Figure 24. Maintenance
Menu
The Power Loss List displays up to three power failure start times. If more occurred, the
first and last two start times will be displayed.
VIEWING THE POWER LOSS LIST
1. Press the MENU button. The Main menu appears.
2. Turn the JOG dial to select MAINTENANCE, and then turn the SHUTTLE ring right.
The Maintenance menu appears.
3. Turn the JOG dial to select POWER LOSS LIST, and then turn the SHUTTLE ring
right. The Power Loss List appears.
4. Press the MENU button. The day and time display appears.
CLEARING THE POWER LOSS LIST
1. Press the MENU button. The Main menu appears.
2. Turn the JOG dial to select MAINTENANCE, and then turn the SHUTTLE ring right.
The Maintenance menu appears.
3. Turn the JOG dial to select POWER LOSS LIST CLEAR, and then turn the SHUTTLE
ring right.
(If you change your mind at this point and want to exit the menu without clearing the
list, skip to step 5.)
4. Turn the SHUTTLE ring left to clear the list. The Maintenance menu appears.
5. Press the MENU button.
Once the list is cleared, the power loss list indicator (PL) goes off.