Filter
Top Products
60 Pelco Manual C673M (2/01)
WHEN CONTROLLING MULTIPLE VCRS
Set VCR ADDRESS for each VCR in the RS-232C menu to different addresses (from
VCR01 to VCR255, except NONE).
• When you want to control a specific VCR, enter its address (for example, VCR01) and
a comma before entering the command code.
• When you want to control all connected VCRs, enter ALL and a comma before
entering the command code.
Command: Commands sent to the VCR.
Format :
VCR ADDRESS
or ALL
Command
Codes
Parameter
1
,
Parameter
2
,
•••••
,
Parameter
n
Delimiter
#1
Status : Response codes from the VCR to outside.
Format :
VCR ADDRESS
Command
Codes
Parameter
1
,
Parameter
2
,
•••••
,
Parameter
n
Delimiter
#2
00493
Figure 34. Commands When Controlling Multiple VCRs
• When you set DELIMITER<RECEIVE> to CR, input the carriage return code (0DH).
When you set DELIMITER<RECEIVE> to CR•LF, input the carriage return code (0DH)
and line feed code (0AH).
• When you set DELIMITER<SEND> to CR, the carriage return code (0DH) will be input.
When you set DELIMITER<SEND> to CR•LF, the carriage return code (0DH) and line
feed code (0AH) will be input.
Example 1
Fast forward the tape in the VCR identified as VCR02 (when DELIMITER<SEND> and
DELIMITER<RECEIVE> on the RS-232C menu are set to CR).
Sending Commands Status or Error Code from
Meaning
from the PC, etc. the VCR to PC, etc.
VCR02, FF CR Command for fast forwarding
(VCR02)
VCR02, RC CR Command received (VCR02)
VCR02, EX CR Command carried out (VCR02)
CR indicates carriage return code (0DH).