Pelco DX4000 DVR User Manual


 
C2602M-A (6/06) 35
To modify relay outputs
1. Select Alarm from the main menu, and then press the Enter button. The Alarm menu appears.
2. Select Relay Output Setup, and then press the Enter button. The Relay Output Setup menu appears.
Figure 39. Relay Output Setup Menu
3. For each alarm, modify the following relay settings:
Select an alarm, and change its relay output to Enable or Disable.
Change the relay mode to Latched or Transparent.
For latched relays, select a duration. Durations can last as little as five seconds, as long as five minutes, or until an operator manually
turns off the relay with a key (Until Key-In).
4. Select the Relay Type field and set the relay to normally open (N/O) or normally closed (N/C).
5. After these settings are modified, press the Return button until all menus are cleared. A message appears stating that the settings are
being saved.