Filter
Top Products
C2602M-A (6/06) 53
To set up recording schedules
1. From the remote agent application main screen, click the Setup button if the Settings screen is not open. The Settings screen
appears and the Remote Agent tab is displayed.
2. Open the DVR System tab, and then click the Record tab.
3. Under the Timer Recording settings, configure the following information for each camera:
• Record: Set this to On or Off.
• Mode: Select the recording schedule. Choices are Daily and Weekly. If you select Weekly, the Timer Recording Setup screen
(Figure 68) appears. The DX4000 records during the hours that are shaded. Blank hours are not recorded. Select hours by clicking in
each square, or drag your mouse across a row or block of squares. Right-click to use the shortcut menu to select, deselect, or cancel
your settings.
• Start: Select the hour at which recording should start. The schedule is based on a 24-hour clock. If you select 0, recording will start
just after midnight. For example, select 23 to begin recording at 11:00 PM, or 2300 hrs.
• Stop: Select the hour at which recording should stop. The schedule is based on a 24-hour clock. For example, select 23 to stop recording
at 11:00 PM, or 2300 hrs.
4. Click the Apply button to save the changes and continue to other settings. If you are finished updating settings, click the OK button to close
the screen.
Figure 68. Timer Recording Setup Screen