Filter
Top Products
C2639M-B (8/09) 5
Important Safety Instructions
The system and data hard disk drives (HDD) for the DX8100 Series are installed inside the DX8100 chassis.
The DX8100 must be taken offline and shut down before starting the upgrade process. Before continuing
with the HDD upgrade procedure, read these safety instructions.
1. Read the Important Safety Instructions that came with the DX8100. You can access this document
on the Pelco Web site at www.Pelco.com, and navigate to Products/Video Recording Solutions/
Hybrid Video Recorders/Hybrid Video Recorders/DX8100 Series Hybrid Video Recorders Version 2.0/
Documents.
2. The security surveillance service provided by the DX8100 is interrupted when it is taken offline.
3. The unit must be shut down to install the system and data disk.
4. Unplug the power cord from the wall socket, and then unplug it from the rear of the HVR/DVR.
5. Only use attachments/accessories specified by the manufacturer.
6. Make sure you protect the unit and its components from electrostatic discharge (ESD).
7. The currently installed data drive might contain recorded data. In this case, if required to remove a
data drive, label the drive to ensure that the drive is reinstalled in the same location.
The product and/or manual may bear the following marks:
This symbol indicates that dangerous voltage
constituting a risk of electric shock is present within
this unit.
This symbol indicates that there are important
operating and maintenance instructions in the
literature accompanying this unit.
WARNING: It is critical that the DX8100 be unplugged for your safety. You must remove the
power cord because current continues to flow through the unit even when it is off.
WARNING: This product is sensitive to Electrostatic Discharge (ESD). To avoid ESD damage to this
product, use ESD safe practices during installation. Before touching, adjusting or handling this product,
correctly attach an ESD wrist strap to your wrist and appropriately discharge your body and tools. For
more information about ESD control and safe handling practices of electronics, please refer to ANSI/
ESD S20.20-1999 or contact the Electrostatic Discharge Association (www.esda.org).
CAUTION:
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
The materials used in the manufacture of this document and its components are compliant to the requirements of
Directive 2002/95/EC.
This equipment contains electrical or electronic components that must be recycled properly to comply with Directive
2002/96/EC of the European Union regarding the disposal of waste electrical and electronic equipment (WEEE).
Contact your local dealer for procedures for recycling this equipment.