Filter
Top Products
Perle 10/100/1000 Ethernet Media Converter
10
Using SFP’s with SGMII Interfaces
This media converter
*
is able to operate with SFP’s that utilize an
SGMII interface. This feature is enabled on the S-1110-SFP
model through the hardware strapping listed below.
• To set SGMII Interface support on SFP port one, strap pins 1
and 3 on jumper J3 (see diagram below).
• To set SGMII Interface support on SFP port two, strap pins 4
and 6 on jumper J3 (see diagram below).
*
SFP’s with SGMII Interface are supported on certain S-1110-SFP
models. The last 5 digits of the serial number on these models
must begin with the number 17 or greater.
Installing the Duplex Fiber Cable
Locate a 1000Base-X compliant duplex (2 strands) fiber cable with
appropriate connectors.
Connect the fiber cables from one media converter to the other
media converter/switch/fiber device ensuring that the RX and TX
are reversed (crossed) at the opposite end.