Filter
Top Products
Perle 10/100/1000 Ethernet Media Converter
12
Powering up the Perle Media Converter
using the supplied Power Adapter
1.
Connect the Perle supplied power adapter to the Media
Converter.
2.
Connect the power adapter to a power source.
3.
Check that the PWR LED light is lit.
Terminal Block Connector
1.
Ensure the Power Source is off.
2.
Unplug the terminal block from the Media Converter
3.
Strip insulator sheathing from both wires 5mm (3/16
th
inch) to
expose the copper conductor wire.
4.
Loosen the terminal block screws and connect Positive (+)
wire to the left terminal. Connect the Negative (-) wire to the
right terminal. Tighten Terminal screws (0.22Nm-0.25Nm
torque).
5.
Turn on power source.
6.
Check that the PWR LED light is lit.
Attaching the Power cord strain relief
clip
For extra power cable strain relief, attach the strain clip to the case
as shown below, then thread the power cable through the clip in
either one or two loops.