Filter
Top Products
Perle 10/100/1000 Ethernet Media Converter
3
Extended Temperature Models with Terminal Block
Connector
Model
Connector
(xx)
Mode - Distance
Wavelength
(TX/RX)
S-1110-M2xx05-XT SC/ST/LC MM - 550 m/1804 ft. 850 nm
S-1110-M1SC05U-XT SC MM - 2km /1.2 km 1310/1550 nm
S-1110-M1SC05D-XT SC MM - 2km /1.2 km 1550/1310 nm
S-1110-S2xx10-XT SC/ST/LC SM – 10 km/6.2 miles 1310 nm
S-1110-S1SC10U-XT SC SM -10 km/6.2 miles 1310/1490 nm
S-1110-S1SC10D-XT SC SM -10 k m/6.2 miles 1490/1310 nm
S-1110-SFP-XT SFP
Note 1
Note 1: Fiber characteristics will depend on the SFP fiber module selected
For more information on Installation guides, models and
specifications, see
http://www.perle.com/
Installation
The default DIP switch settings (all switches in the UP position)
will work for most installations.
These are the steps required to configure the Perle S1110
Ethernet media converter:
1. Insert SFP Module.(SFP Model only)
2. Set the AUTO-MDIX jumper setting. (optional)
3. Set the DIP switch settings. (optional)
4. Attach the power cord strain relief clip. (optional)
5. Install and connect the fiber cable.
6. Install and connect the copper cable.
7. Power up the media converter.