Filter
Top Products
Perle 10/100/1000 Ethernet Media Converter
9
When using Fast Ethernet
Full/Half Duplex on Fiber (Switch 6)
Switch Position Mode
Up (default) Full
Down Half
Full:
The Media Converter Module will be set to Full Duplex mode
on its fiber link.
Half:
The Media Converter Module will be set to Half Duplex
mode on its fiber link.
Loopback (Switch 7)
Switch Position Mode
Up (default) Disabled
Down Enabled
Disabled: The loopback feature is disabled. This is default
position for normal operation. The switch must be set to this
position in order for data to pass through the media converter.
Enabled: This is a test mode. All data received on the receive
(RX) fiber connection is looped back to the transmit (TX) fiber
connection. The state of the copper link is not relevant since no
data is passed through to the copper side. This mode will override
all other switch settings.
Installing the SFP Fiber Module
The S-1110-SFP model requires an SFP fiber module. Locate
appropriate fiber module and insert the SFP into the opening on
the front of the media converter.
1. Ensure the SFP module is properly seated.
2. The SFP module may be inserted before or after applying
power to the media converter
3. Proceed with cable connections.