Filter
Top Products
L05 User’s Manual 091105.1833
4
Basic Television Connection
Antenna Connection
• Connect the antenna or RF cable
signal to the 75-ohm RF ‘F’ connector
socket located on the TV’s rear jack panel.
Mains Connection
• Verify that the mains voltage and
frequency are correct. Please refer to the
product labeling and documentation.
Note: The power button on the front panel
does not disconnect the television from the
AC mains; it toggles the TV’s power mode
between on and standby. To completely
remove AC mains power, you must unpl
ug
the AC mains plug.
Switching on the Set
• Press the power button on the TV’s front
panel or on the remote control to switch on
the set.
Note 1: If the TV is in commercial mode, it
might not respond to the front panel or the
remote control, depending upon the TV’s
mode and setup configuration. Please refer
to the section TV Installation and TV
Setup Menu in this documentation for
more information.
Note 2: See Mains Connection, above.