Filter
Top Products
39
LIST OF SETTINGS
EN
EN
Category Menus / Options Description
Advanced Setup
Audio Night Mode Auto Compresses the range between soft
and loud sounds.
“Auto”:
Night Mode will be activated
automatically when Dolby TrueHD
audio is played back.
“On”:
Activates the Night Mode.
“Off”:
Deactivates the Night Mode.
On
Off
Down Sampling
On Sets the sampling rate for outputting
the PCM audio from the digital output
(coaxial).
“On”:
Over 96 kHz PCM audio will be down
sampled at 48 kHz.
“Off”:
For BD or DVD recorded in LPCM
without copyright protection,
2-channel audio signals up to 96 kHz
are output as LPCM signals.
Off
Virtual Surround On Select “On” to enjoy the stereophonic
virtual space through your existing 2
channel stereo system during
playback of BD-video or DVD-video.
Off
Blu-ray Disc Audio
Mix Audio Output “Mix Audio Output”:
The audio for the secondary video and
the interactive application will be
output together with the audio for the
primary video.
“Primary Audio Only”:
Only the audio for the primary video
will be output.
When playing back a BD-video which
only contains the primary audio, the
audio output will be the same case as
the “Primary Audio Only” even if the
“Blu-ray Disc Audio” is set to “Mix
Audio Output”.
Primary Audio Only
HDMI Audio
•This feature is
available only when
the display device is
connected by an
HDMI cable.
• Refer to page 44 for
more information.
HDMI Normal Sets the audio format for the sound
output from the HDMI OUT jack.
PCM
Off
Digital Out
• When HDMI cable is
connected, make
sure “HDMI Audio”
setting is set to “Off”
to change the
“Digital Out”
setting.
• Refer to page 46 for
more information.
Bitstream Sets the audio format for the sound
output from the DIGITAL OUT
(COAXIAL) jack.
PCM
Introduction Connections Basic Setup Playback OthersFunction Setup