Filter
Top Products
English
13
Installation
Setting the clock
The time is displayed using the 12-hour clock.
1 Check the set is switched to standby mode.
(see Basic Functions, Switch on/to
standby)
➜--:-- flashes by default if the clock is not set.
2 On the set, press CLOCK on the set.
➜ The hour digits start flashing (AM 12: 00 by
default).
3 Hold down or press TUNING ∞ / § ( + - )
on the set to set the hour. Release TUNING
∞ / § ( + - ) when you have reached the
correct setting.
4 Press CLOCK to confirm the setting.
➜ The minute digits start flashing.
5 Repeat step 3 to set the minute.
6 Press CLOCK to confirm the setting.
➜ The clock shows the set time.
Helpful hints:
–You may lose your clock setting when the power
cord is disconnected or power failure occurs.
Using the TV screen
The set is equipped with a 8.5” TFT LCD
monitor. You can watch TV on it. If you insert a
disc, it will serve as an additional display for
messages (e.g. PLAY, STOP), and information
stored on the disc.
1 Press PUSH at the bottom of the set to release
TV panel.
2 Pull the down the panel (maximum 110
0
).
3 Tu rn around the panel to find the screen.
4 Adjust the screen to a suitable angle (maximum
270
0
).
PUSH
1
2
3
4
pg001-pg017_DCD778_37-EngA 9/2/07, 18:5013