Filter
Top Products
34
English
WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If
you are unable to remedy a problem by following these hints, consult your dealer or
PHILIPS for help.
Problem
Solution
Troubleshooting
Disc cannot play
No sound
No picture
Remote control does not work
✔ Make sure a disc is loaded.
✔ Make sure a disc is loaded with the label side up.
✔ Disc dirty or damaged. Clean the disc.
✔ Make sure the region code of the player is the
same as that of the DVD disc loaded.
✔ Moisture has condensed in the player. Remove
the disc and leave the player power-on until the
moisture evaporates.
✔ Check whether the set is connected securely.
✔ Make sure the set is not in the MUTE mode. If it
is, press MUTE to turn on the speaker.
✔ Check whether the volume on the set has been
set to the lowest level. If it has, turn up the
volume.
✔ Check whether the set is connected securely.
✔ First, select the source you wish to control by
pressing a source button (DVD, RADIO or TV
for example). Then, select the desired functions
(í,
ë, for example).
✔ Remove obstacles between the remote control
and the player, and point directly instead of at a
wide angle at the infrared sensor on the player.
✔ Make sure the battery has been inserted
properly (check polarity).
✔ Battery maybe exhausted. Replace the battery
with a new one.
Radio reception is poor.
✔ If the signal is too weak, adjust the antenna or
connect an external antenna for better
reception.
✔ Increase the distance between the set and a TV,
VCR or radiation source.
The Clock setting is erased.
✔ Power has been interrupted or the power cord
has been disconnected. Reset the clock.
pg018-pg035_DCD778_37-EngB 9/2/07, 18:5134