Philips DVP3050V/51 DVD VCR Combo User Manual


 
The region code for this set is 5.
Since it is usual for DVD movies to be released
at different times in different regions of the
world,all players have region codes and discs
can have an optional region code. If you load a
disc of a different region code to your player,
you will see the region code notice on the
screen. The disc will not playback,and should be unloaded.
Manufactured under license from Dolby Laboratories.“Dolby”
and the double-D symbol are trademarks of Dolby Laboratories.
This product incorporates copyright protection technology
that is protected by U.S.patents and other intellectual property
rights.Use of this copyright protection technology must be
authorized by Macrovision,and is intended for home and other
limited viewing uses only unless otherwise authorized by
Macrovision.Reverse engineering or disassembly is prohibited.
2
English
General Information
Thank you for purchasing this Philips DVD/ VCR.This Owner’s
Manual explains the basic operation of this unit.
Environmental Information
All unnecessary packaging has been omitted.
Packaging has been made easy to separate into three materials:
cardboard (box),polystyrene foam (buffer) and polyethylene
(bags,protective foam sheet).
Your DVD/VCR consists of materials which can be
recycled and reused if disassembled by a
specialised company. Please observe the local
regulations regarding the disposal of
packaging materials,exhausted batteries and old
equipment.
Supplied Accessories
• Remote control •
Batteries (two AA size) for Remote control
• RCA connector plug • RF Coaxial cable • Owner’s Manual
Safety Information
• To reduce the risk of fire or electric shock,do not expose
this device to rain or moisture.
• Before operating the DVD/VCR,check that the operating
voltage indicated on the typeplate (or the voltage indication
beside the voltage selector) is identical with the voltage of
your local power supply. If not,please consult your dealer.
• Place the DVD/VCR on a flat,hard and stable surface.
• There must be sufficient room in front of the player for the
disc tray to be opened.
• In cabinet,allow about 2.5cm (1inch) of free space all around
the player for adequate ventilation.
• Do not expose your player to extreme of temperature or
humidity.
• If the DVD/VCR is brought directly from a cold to a warm
location,or is placed in a very damp room,moisture may
condense on the lens of the disc unit inside the DVD/VCR
player.Should this occur,the DVD/VCR would not operate
normally.Leave the player on for about one hour with no disc
in the DVD/VCR until normal playback is possible.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
• Never spill liquid of any kind on this unit.If liquid is spilled
into the unit,consult qualified service engineer.
• Do not stand the unit up vertically.Install the unit in a
horizontal and stable position.
• Be sure to remove the disc and unplug the AC power cord
from the output before carrying the unit.
When the DVD/VCR is switched to Standby mode,it
is still consuming some power. To disconnect the
system from the power supply completely, remove
the AC power plug from the wall socket.
Introduction
This product complies with the requirements of Directive
73/23/EEC +89/336/EEC +93/68/EEC.
Laser safety
This unit employs a laser.Due to possible eye injury,only a
qualified service person should remove the cover or attempt
to service this device.
USE OF CONTROLS OR ADJUSTMENTS OR
OF PROCEDURES OTHER THAN THOSE
SPECIFIED HEREIN MAY RESULT IN HAZARDOUS
RADIATION EXPOSURE.
5
The DVD/ VCR is in conformity with the
EMC directive and low-voltage
directive.
For Customer Use:
So that you can identify your machine for service questions
or in the event of theft,enter the serial number here.The
serial number (PROD. NO.) is printed on the type plate
fixed at the back of the device.
Model No.DVP3050V
Serial No.________________________________________
LASER
Type Semiconductor laser GaAlAs
Wave length 655 nm (DVD)
790 nm (VCD/CD)
Output Power 0.8 mW (DVD)
0.5 mW (VCD/CD)
(WARNING
LOCATION:
ON THE BACK-
PLATE OF SET)
CLASS 1 LASER PRODUCT
KLASSE 1 LASER PRODUKT
KLASS 1 LASER APPARAT
CLASSE 1 PRODUIT LASER
About the PBC Function of Video CD
• This unit conforms to ver.1.1 and ver.2.0 of Video CD
standard,with PBC function.
Ver.1.1 (without PBC function):You can enjoy playback picture
as well as music CD.
Ver.2.0 (with PBC function):When using a Video CD with
PBC function,“PBC” appears on
the display.
• “PBC” stands for Play Back Control.
• Video CD with PBC function has its original menu.Menu
operation may vary depending on the disc.Refer to the
manual included in the disc for details.
• “PBC” appears on the front panel display when a Video CD
with PBC function is loaded.
H9924RD_EN_0318 3/18/05 11:22 AM Page 2