Filter
Top Products
14
Programming a Recording (TIMER)
How to check, or delete a programmed
recording (TIMER)
1 Press VCR,then DISC/VCR MENU.
2 Press K/L to select “TIMER”.Then
press B.
3 Press K/L to select “TIMER LIST” ,
then press B.
4 Select timer block with B.
5 To cancel the recording,press CLEAR.
6 To end, press STATUS/EXIT.
7 Press TIMER SET.
SELECT KL CHOOSE B
ONCE
DAILY
WEEKLY
→TIMER LIST
END=EXIT
How to change a programmed recording
(TIMER)
1 Press VCR,then DISC/VCR MENU.
2 Press K/L to select “TIMER” ,then press B.
3 Press K/L to select “ONCE”,
“DAILY”, or “WEEKLY” recording
with K/L , then press B.
4 Select a TIMER block with numeri-
cal key pads. (The flashing number
indicates an empty TIMER block.)
5 Press CLEAR to delete information
and input correct information with
numerical key pads.
6 To end, press STATUS/EXIT.
7 Press TIMER SET.
ONCE
TIMER - 1 2 3 4 5 6 7 8 -
SELECT TIMER NUMBER
END=EXIT
Timer block disappeared when I pressed
g
.
You have checked all the programmed recordings.If you want to
check them again,repeat steps 1 to 4.
Hint for Timer Recording
• If there is a power failure or the DVD/ VCR is unplugged for
more than 1 minute,the clock setting and all timer settings
will be lost.
• If a tape ends during TIMER RECORDING,the DVD/ VCR will
stop,eject the tape,and switch to the DVD mode automati-
cally as the TIMER light blinks.(If the DVD power is off, the
DVD/ VCR will become the STANDBY status).
• If a tape is not in the DVD/ VCR or does not have a record
tab,the TIMER light flashes and timer recording will not oper-
ate. Please insert a recordable tape.
• When timer recordings are set, the TIMER light will come on.
To use the DVD/ VCR as usual until the time for the record-
ing,press TIMER SET so that the TIMER light disappears. Press
DVD/ VCR to choose VCR or DVD modes,then continue
with the other features as described in this manual.
'PRESS TIMER SET BUTTON FOR TIMER RECORDING'
appears on the screen
* Press TIMER SET on several minutes before the start of a pro-
grammed recording.