Filter
Top Products
- 14 - EN
A Status Display
Make sure ...
• You must use the remote control for this procedure.
A status display, which includes the current time, channel, and other information (see illustration) will
appear when you press [STATUS/EXIT] or certain function buttons. The contents of the status dis-
play may vary. There are three status display modes:
Blue Background
STOP
SP M 1:23:45
12:00
P 10
Time
Channel
Tape Speed
Counter and
Counter Memory
Function
Button Pressed
If you want the TV screen to be solid blue when
a weak signal is received, set BLUE BACK-
GROUND to “ON”. The screen will be blue and
the sound will be muted. Or, if you want to
receive the weak signal, set BLUE BACK-
GROUND to “OFF”.
1. Press [VCR].
2. Press [MENU].
3. Press [PLAY/K] or [STOP/p] to select “VCR
SET UP”, then press [F.FWD/B].
4. Press [PLAY/K] or
[STOP/p] to select “BLUE
BACKGROUND”. Then,
press [F.FWD/B] to select
“OFF” (or “ON”).
5. Press [STATUS/EXIT] to
exit.
STATUS ON:
• When you press [STOP/L] or [PLAY/K], the
status display appears for five seconds.
COUNTER ONLY ON:
• When you press [STOP/L] or [PLAY/K], the
status display appears for five seconds. After
five seconds, only the counter will remain on-
screen. Press [STATUS/EXIT] to remove it.
STATUS OFF:
• The status display will not appear when you
press function buttons.
• You must press [STATUS/EXIT] to see the
status display.
1. Press [VCR].
2. Press [MENU].
3. Press [PLAY/K] or [STOP/L] to select “VCR
SET UP”, then press [F.FWD/B].
4. Press [PLAY/K] or
[STOP/L] to select “ON
SCREEN MODE”, then
press [F.FWD/B].
5. Press [F.FWD/B] to select
“STATUS ON” or “OFF”.
6. If you set “STATUS” to “OFF”, go to step [7]. If
you set “STATUS” to “ON”, press [PLAY/K] or
[STOP/L] to select “COUNTER ONLY”, then
press [F.FWD/B] so that “OFF” (or “ON”)
appears beside it.
7. Press [STATUS/EXIT] to exit.
SELECT op CHOOSE B
REPEAT PLAY [ON]
→ ON SCREEN MODE
BLUE BACKGROUND
[ON]
END = EXIT
SELECT op CHOOSE B
REPEAT PLAY [ON]
ON SCREEN MODE
→
BLUE BACKGROUND[
ON]
END = EXIT
Make sure ...
• You must use the remote control for this procedure.
H87T4(EN)BACK.QX33 01.7.3 6:45 PM Page 14