Philips VR102 VCR User Manual


 
- 15 - EN
Troubleshooting Guide
If you have followed the instructions contained in this manual and have difficulty in operating your
VCR, locate the SYMPTOM in the left column below. Check the corresponding CORRECTIVE
ACTION columns to remedy the problem.
SYMPTOM CORRECTIVE ACTION
Timer recording is
not possible.
Make sure the timer recording is set correctly.
Make sure the power is off.
Make sure the VCR clock is set correctly.
Recording mode
cannot be engaged.
Make sure the tape has an erase-protection tab. If needed, cover the
hole with plastic tape.
No picture or poor
picture on playback.
Set your TV to the video channel.
Fine tune your TV.
No picture but the
audio is OK in play-
back.
Head cleaning is necessary, consult the nearest Authorized Service
Center.
Playback picture is
partially noisy.
Adjust tracking control for a better picture by using [PROGRAMME (-/+)]
on the VCR.
On-the-air TV pro-
grammes cannot be
seen.
Re-check the AERIAL and RF OUT connections.
Set your TV to the TV channel correctly.
No operation by
infrared Remote
Control.
Check the batteries in the remote control.
Press [VCR] on the remote control, then try again.
Video or colour
fades in and out
when making a copy
of a video tape.
You cannot copy a copyrighted video tape. You are experiencing copy
guard protection.
No power. Make sure the mains cord is connected to an AC outlet.
Make sure the power is turned on.
H87T4(EN)BACK.QX33 01.7.3 6:45 PM Page 15