Filter
Top Products
General information
DYou can switch on with STANDBY/ONm , the number
buttons 0-9 or by putting in a cassette.
DIf you have not used the video recorder for a few
minutes, it will switch to standby automatically. For
more information, please read the section
’Automatic switch-off’ in chapter ’additional
functions’.
DIf you have switched the video recorder off with
STANDBY/ONm , the time will show in the display, for
instance , ’18:00’.
If the clock has not been set, ’--:--’ will appear.
DWhen the video recorder is switched off and the
time isn’t shown in the video recorder display, the
clock display may be switched off. You will find more
information in the section ’Saving energy’.
DKeep your video recorder connected to the mains at
all times to ensure that programmed recordings can
be made and that the television works normally.
Your video recorder uses less than 4 Watts (with
clock-display switched off).
DIf the video recorder is not plugged into the mains, it
will usually store TV channels for one year and timer
and date information for three hours.
Saving energy
To save energy, you can switch off the clock display on the
video recorder. Programmed (TIMER ) recordings will take
place even if the clock display has been switched off.
a Switch on the TV set. If required, select the programme
number for the video recorder.
b Press MENU on the remote control. The main menu will
appear.
c Select the line ’SPECIAL SETTINGS’ with rP = or
;P q and confirm with OK .
SPECIAL SETTINGS
OSD è ON p
CLOCK DISPLAY OFF
COUNTER T.LEFT
SAT RECORDING OFF
REPEAT PLAY OFF
DIRECT RECORD OFF
________________________________
EXITpMENU STOREpOK
d To switch off the clock display on the video recorder,
select ’OFF’ in line ’CLOCK DISPLAY’ with P .
DTo switch the clock display on, select ’ON’.
e Confirm with OK .
’STORED’ will briefly appear on the TV screen.
f To end, press MENU .
Emergency interrupt
You can use STANDBY/ON m on the video recorder or the
remote control to interrupt any function.
So if you are having operating problems, you can just interrupt
the function and start again.
And you can practise operating your set without any worries.
No matter which buttons you press, you cannot damage it.
3. IMPORTANT NOTES FOR OPERATION
11