Philips VR605A/58 VCR User Manual


 
DWhile a programmed recording is being made, you
cannot operate your video recorder manually. If you
want to cancel the programmed recording, press
STANDBY/ONm .
DIf you reach the end of the cassette during a
recording, the video recorder will automatically
eject the cassette.
DIf you have put in a cassette that cannot be
recorded on, the cassette will be ejected.
PROTECTED CASSETTE’ will briefly appear on
the TV screen.
DIf the video recorder is switched on a few minutes
before a programmed recording is to start, ’SWITCH
TO STANDBY- TIMER RECORDING’ will flash
on the TV screen.
DIf you forget to put a cassette in the machine, ’NO
CASSETTE’ will appear on the TV screen. ’k’ will
flash In the video recorder display.
DIf ’ALL TIMERS OCCUPIED’ appears on the TV
screen when you press TIMERk , you have used up
all the available TIMER blocks. If you want to clear
or check a programmed recording (TIMER block),
select it with ;P q or rP = .
DIf ’DATA ERROR’ briefly appears on the screen, this
means that the TIMER information has not been
transferred. Please check date, start time and end
time of the programmed recording
DProgramme numbers ’E1’ and ’E2’ are for
recordings from other sources (through scart socket
AV1 EXT1 or AV2EXT2 ).
Programming a recording with ’TURBO
TIMER’
With the ’TURBO TIMER’, programming a recording that takes
place within the next 24 hours, will be quick and easy. This
preset information will appear in the display:
Programme number = the programme number selected on
your TV
Start time = current time
End time = current time + 2 hours
a Press TURBO TIMER on the remote control.
The currently selected programme number will appear in
the display, for instance, ’PROG. 01’. If required, change
the programme number with rP = or ;P q .
01
DIf ’CLK’ briefly appears in the display, you must set
the clock. Please read the section ’Setting the time
and date’ in chapter ’INSTALLING YOUR VIDEO
RECORDER’
b Press TURBO TIMER .
The current time (= start time) will appear in the display,
for instance, ’START 20:00’. If required, change the
start time with rP = or ;P q .
20:00
c Press TURBO TIMER .
The end time will appear in the display, for instance,
END 22:00’. If required, change the end time with
rP = or ;P q .
22:00
d Press TURBO TIMER .
OK’ will briefly appear in the video recorder display.
Programming is now complete.
e Make sure that the cassette you have put in can be
recorded on.
f Switch off with STANDBY/ONm .
The programmed recording will only function when the
video recorder is switched off with STANDBY/ONm .
22