Filter
Top Products
DUse the SELECT button to switch ’VPS/PDC’ on or off
in ’START’.
DUse the SELECT button to select the recording
speed ’SP’ or ’LP’ in ’END’.
g Confirm with the OK button when the information is
correct.
DThe programming information has been stored in a
TIMER block.
h To end, press the TIMERk button.
i Make sure that the cassette you have put in can be
recorded on.
DThe cassette is being checked. Wait until the search
symbol in the display has gone out. More
information on the Tape Manager can be found in
the chapter ’The Tape Manager (TM)’.
j Switch off with the STANDBY m button.
The programmed recording will only function when the
video recorder is switched off with the STANDBYm
button.
DIf any of the TIMER blocks are in use, ’k’ will light up
on the video recorder display.
DWhile a programmed recording is being made, you
cannot operate your video recorder manually. If you
want to cancel the programmed recording, press the
STANDBY m button.
DIf the video recorder is switched on a few minutes
before a programmed recording is supposed to
begin, ’SWITCH TO STANDBY - TIMER
RECORDING’ will flash on the TV screen.
DIf you reach the end of the cassette during a
recording, the video recorder will automatically
eject the cassette.
DIf you forget to load a cassette, ’NO CASSETTE’
will appear on the TV screen and ’k’ will flash on the
video recorder display.
DIf you have put in a cassette which cannot be used
for recording, the video recorder will automatically
eject it.
DIf ’TIMER FULL’ appears on the TV screen when
you press the TIMER k button, you have used up all
the available TIMER blocks. If you want to clear or
check a TIMER block, select it with the ;P or
P = button.
DProgramme number ’AUX’ is provided for audio
recordings via sockets AUX INL R .
Programming a recording
(without ’VIDEO Plus+’)
a Switch on the TV set and select the programme number
for the video recorder.
b Press the TIMERk button on the remote control.
The programming mode selected last is marked.
c Select the line ’TIMER PROGRAMMING’ with the
P = or ;P button and confirm with the P button.
TIMER
TIMER PROGRAMMING
VPS
DATE PROG. START PDC END LP
01 01 20:00 21:30
________________________________
MO-FR/WEEKLY TO STORE
PRESS SELECT PRESS OK
d Select the entry field with the Q or P button.
e Enter information with the P= or ;P button or with
the digit buttons 0-9 .
DUnder ’DATE’, use the SELECT button to select daily
or weekly programming.
’MO-FR’: Recording from Monday to Friday.
’MO’: Recordings every week on the same day.
DUnder ’START’, use the SELECT button to switch
’VPS or PDC’ on or off.
DUnder ’END’, use the SELECT button to select the
recording speed ’SP’ or ’LP’.
f Confirm with the OK button when the information is
correct.
DThe programming information has been stored in a
TIMER block.
g To end, press the TIMERk button.
h Make sure that the cassette you have put in can be
recorded on.
DThe cassette is being checked. Wait until the search
symbol in the display has gone out. More
information on the Tape Manager can be found in
the chapter ’The Tape Manager (TM)’.
24