Filter
Top Products
02
16
En
Connecting video and
audio cables
Note
• Make the settings in the Setup Navigator menu
according to the type of cable connected (page 18).
•To outp ut video signals from this player, connect
using one of the following (not including when
connected using an HDMI cable): a component video
cable or a video cable.
Connecting a TV using a
video/audio cable
Caution
• Connect the player’s video output directly to
your TV.
This player supports analog copy protection
technology. Therefore the picture may not be
displayed properly if connected to a TV via a DVD
recorder/video deck or when playing the player’s
output material that is recorded by a DVD recorder/
video deck. Furthermore, the picture may not be
displayed properly due to the copy protection when
the player is connected to a TV with a built-in video
deck. For details, contact the manufacturer of your
TV.
Note
•V
id
eo signals are output with a resolution of 576/50i
or 480/60i when connected using a video cable.
• When connected to the TV using a component video
cable, video signals are not output with a resolution of
1080/50i, 1080/50p, 720/50p, 1080/24p or 1080/60p.
•Depending on the output video resolution setting, the
picture may not be output (page 21).
Connecting an AV receiver or
amplifier using an optical
digital audio cable
Note
• To switch the video from the AV receiver or amplifier,
also connect the video output terminals.
Connecting components
to the USB port
The data downloaded with the BD-LIVE function and the
data used with the BONUSVIEW function when playing
BD-ROMs can be stored on a device connected to the
USB port (external storage).
About USB (external storage)
devices
The USB (external storage) devices that can be
connected to the player are as shown below.
•USB 2.0-compatible memory devices or hard disks
• FAT16 or FAT32 file system, minimum 1 GB capacity
(2 GB or more recommended)
Note
• Devices formatted with a file system other than the
above cannot be used. Such devices may however be
usable if they are formatted from the player.
•External storage devices may not be recognized if
they contain multiple partitions.
• Some external storage devices may not operate with
this player.
•Operation of external storage devices (USB memory
devices, external hard disks, etc.) is not guaranteed.
OUTPUT
COMPONENT VIDEO
CONTROL
IN
Y
R
AUDIO
VIDEO
L
P
B
P
R
TV
Player’s rear panel
To component
video input terminals
A component cable or
three commercially
available video cables
can be used instead
of the video cable
(yellow plug) of the
included video/audio
cable for connection.
Direction of
signal flow
Red
White
It is also possible to
connect to an AV
receiver or amplifier.
Connect the audio
signals using an
optical digital audio
cable or an audio cable
(2 channels) (below).
To video/audio
input terminals
Video/audio
cable (included)
Yellow
LAN (100)
HDMI OUT
OUTPUT
COMPONENT VIDEO
DIGITAL
OUT
OPTICAL
CONTROL
IN
Y
R
AUDIO
VIDEO
L
P
B
P
R
USB
(BD STORAGE)
Player’s rear panel
To audio input
terminals
AV receiver or
amplifier
Direction of signal flow
2-channel analog
audio can also be
connected.
To optical digital
audio input terminal
Optical digital audio
cable (commercially
available)
Red
White
Video/audio cable
(included)
320_VXJ5_IBD_EN.book 16 ページ ２００９年２月２５日 水曜日 午前１０時５７分