Filter
Top Products
64
<VRB1210>
Troubleshooting
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component,
check the points below. Sometimes the trouble may lie in another component. Inspect the other components and electrical appliances
being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized
service center or your dealer to carry out repair work.
Symptom
1.The disc comes back out
even when the disc table is
closed.
2.Playback is not possible.
3.Picture disturbance during
playback.
4.When recorded on a VCR
there is disturbance in the
playback picture.
5.
mark appears on screen.
6.Picture playback stops and
the operation button can not
be used.
7.Remote control operation is
not possible.
8.Improper operation of TV set,
etc., occurs.
9.Audio is not output or is
distorted.
10. Noticeable difference in
DVD and CD
volume.
Possible causes
÷ The disc is dirty or warped.
÷ The disc is not placed properly on the disc table.
÷ Region No. does not conform with this unit.
÷ Condensation has formed inside the player.
÷ This player cannot play PAL and SECAM format DVD
discs.
÷ This player is compatible with Macro-Vision System
copy guard. Some discs include a copy prevention
signal, and when this type of disc is played back,
stripes etc., may appear on some sections of the
picture depending on the TV. (This is not a
malfunction.)
÷ This player is compatible with analog copy protect
technology copy guard. Some discs include a copy
prevention signal and the copy guard system will
prevent proper playback.
÷ The selected function does not operate for that disc.
÷ First stop the disc (press the 7 button), then start
playback again.
÷ The rear panel CONTROL IN jack on the player is being
used.
÷ The remote control is too far from the player, or the
angle with the remote sensor is too sharp.
÷ The batteries are exhausted.
÷ Some TVs that have wireless remote control functions
may not operate properly with this remote control.
÷ Digital signal is not output in KARAOKE MODE.
÷ Digital output is prohibited for some discs.
÷ The connection plugs are not inserted fully into the
terminals or are not connected.
÷ The connection plug or terminal is dirty.
÷ Audio cable connection is wrong.
÷ Connection is made to the stereo amplifier's PHONO
input terminal.
÷ The pause mode is engaged.
÷ Stereo amplifier operation is wrong.
(Check input (CD, AUX etc.) selector)
÷ Although you may notice a difference in volume
between CDs and DVDs, this is a the result of a
difference in disc recording methods.
Reference page
p.67
p.10
p.69
p.60
p.8
Operation
Remote control
Audio