Filter
Top Products
Getting started
04
28
En
Playing DVD discs
The table below shows the basic playback controls for
DVD-Video, and recordable DVD discs.
Playing CDs and WMA/MP3 discs
The table below shows the basic playback controls for
audio CDs
1
, and WMA/MP3 files.
Press to start playback.
If
RESUME
is displayed on-screen, play-
back starts from the place last stopped.
Press to stop playback.
You can resume playback from the same
point by pressing
PLAY
. (Press
STOP
again to cancel the resume function.)
Pauses playback, or restarts playback
when paused.
Press to start scanning. Press repeatedly
to increase the scanning speed.
Press to skip to previous/next chapter/title.
(During playback you can also use the
front panel
+/–
buttons.)
Except VR mode:
During playback, enter a
chapter number then press
ENTER
to skip
directly to that chapter within the currently
playing title.
On some discs, you can also use the num-
ber buttons to select numbered items in
the disc menu.
VR mode only:
During playback, enter a
title number then press
ENTER
.
All:
Press
CLEAR
to clear a number entry
and start again.
(Commercial back/skip) Each press skips
backward/forward progressively up to a
maximum of ten minutes forward or three
minutes back.
During playback, press to start slow-
motion playback. Press repeatedly to
change the playback speed.
While paused, press to advance a single
frame in either direction.
Press to display the menu of a DVD-Video
disc.
Use the cursor buttons to navigate DVD-
Video disc menus; press
ENTER
to select
items.
Press to return to the previous level of a
DVD-Video disc menu.
PLAY
STOP
PAUSE
REV SCAN FWD SCAN
PREV NEXT
CLEAR
CLEAR
ENTER
SKIPCMBACK
STEP/SLOW
TOP MENU MENU
ENTER
RETURN
Press to start playback.
Press to stop playback.
Pauses playback, or restarts playback
when paused.
Press to start scanning. Press again to
increase the scanning speed. (There are
two scan speeds; the current scan speed
is shown on-screen.)
Press to skip to previous/next track (or
folder for WMA/MP3 disc). (During play-
back you can also use the front panel
+/–
buttons.)
During playback, enter a track number
then press
ENTER
to skip directly to that
track.
Press
CLEAR
to clear a number entry and
start again.
Note
1. If you want to play a DTS audio CD, make sure the recorder is connected to a DTS-compatible amp/receiver with a digital connection. Noise
will be output through the analog outputs. Also make sure that
STEREO
is selected using the
AUDIO
button (see
Switching audio channels
on page 53).
PLAY
STOP
PAUSE
REV SCAN FWD SCAN
PREV NEXT
CLEAR
CLEAR
ENTER
DVR-330_RL.book 28 ページ ２００５年３月１日 火曜日 午後１０時４７分