Filter
Top Products
The Initial Setup menu
13
93
En
Tuner Settings
Auto Channel Setting Auto Scan
Select your country and then wait for the recorder to auto tune into
channels in your area. After auto scan has finished, the channel map-
ping screen appears showing which channels have been assigned to
which program numbers. You can skip unwanted channels using the
Manual Channel Setting option below.
Press
HOME MENU
to exit the channel mapping screen.
Download from TV
If your TV supports this feature you can download all the channels that
your TV is tuned to via the SCART input. Select your country and then
wait for the download to complete. After the download is complete, the
channel mapping screen appears, as above.
See also the operating instructions that came with your TV for more
information.
Manual CH Setting Next Screen
Proceed to the next screen if you need to adjust any of the settings
made by auto tuning. Select your country, then proceed to the manual
channel setting screen:
• Change channel presets using the
CHANNEL +/–
buttons.
• To skip the displayed channel (because there is no station assigned
to that channel), change the
Skip
setting to
On
.
• Set the
CH SYSTEM
setting to match the channel system of your
country or region.
• Set the
CHANNEL
setting to the channel you want to assign to the
current channel preset.
• To manually fine tune the channel, change the
AFT
setting to
Off
then adjust the
Level
setting.
• The
Name
field allows you to input a name of up to five characters
for the current channel preset.
• If the currently selected channel is scrambled requiring a decoder
connected to the
AV2/AUTO START REC (INPUT 1/DECODER)
, set
the
Decoder
setting to
On
.
Channel Swapping Next Screen
Proceed to the next screen to swap channel assignments of different
presets so that you can group together presets that naturally go
together. Select two presets to swap then press
ENTER
.
Set VIDEO Plus+ CH Next Screen
Proceed to the next screen to assign channel numbers to the guide
channels as necessary. Look in your TV guide to see which channel
numbers should be assigned to which guide channels. Press
ENTER
when your done to leave this screen.
Video In/Out Settings
Input Colour System Next Screen
Proceed to the next screen to set the input colour system for each
channel preset. Use the
CHANNEL +/–
buttons to change the preset.
On the default
Auto
setting the recorder can generally correctly detect
whether the input signal is PAL, SECAM, 3.58 NTSC or PAL-60, but in
some cases you may have to set it manually if the picture is displayed
incorrectly.
See also About the input colour system on page 99 for more information on this setting.
Setting
Options Explanation
DVR-433H_UK.book 93 ページ ２００５年３月１日 火曜日 午後５時６分