Pioneer DVR-433H-K DVD Recorder User Manual


 
The Initial Setup menu
13
94
En
Component Video Out Interlace •
Select if your monitor/TV is not compatible with progressive-scan
video.
Progressive
Select if your monitor/TV is progressive-scan compatible. Check the
operating instructions that came with your monitor/TV if you’re not
sure.
For Component Video Out to be effective, the AV1 Out setting (see below) must be set to something other than
RGB
.
AV1 Out Video •
Sets the
AV1(RGB)-TV
SCART output to standard composite video
(compatible with all TVs).
S-Video
Sets the
AV1(RGB)-TV
SCART output to S-video. Recommended if you
are using a long SCART cable.
RGB
Sets the
AV1(RGB)-TV
SCART output to RGB. Good quality but check
your TV for compatibility.
If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case either switch off and reconnect
using the supplied video cable, or reset the recorder (see Resetting the recorder on page 111).
The Component Video Out setting (see above) has no effect when AV1 Out is set to
RGB
.
AV2/L1 In Video •
Sets the
AV2/AUTO START REC (INPUT 1/DECODER)
SCART input to
standard composite video.
S-Video
Sets the
AV2/AUTO START REC (INPUT 1/DECODER)
SCART input to
S-video.
RGB
Sets the
AV2/AUTO START REC (INPUT 1/DECODER)
SCART input to
RGB.
Decoder
Use this setting if you connected a decoder to the
AV2/AUTO START
REC (INPUT 1/DECODER)
SCART connector. For scrambled channels,
make sure that the channel
Decoder
setting is set to
On
. (See
Manual
CH Setting
on page 93.)
NTSC on PAL TV On •
NTSC discs will play correctly on PAL-only TVs.
Off
Use if your TV is already NTSC-compatible.
Many recent PAL TVs are compatible with NTSC input and so this setting can be switched off. Check the operating instructions that came with
your TV. See also About NTSC on PAL TV on page 99 for related information.
Audio In Settings
Nicam Select NICAM •
Record the NICAM audio in a NICAM broadcast.
Regular Audio
Record the non-NICAM audio in a NICAM broadcast. (You can still
switch the audio to record using the
AUDIO
(
SHIFT
+
1
) button before
recording.)
Tuner Level Normal •
Standard setting.
Compression
Use if the audio level from the built-in tuner is excessive, causing dis-
tortion.
External Audio Stereo •
Select if the audio from the currently selected external input is stan-
dard stereo.
Bilingual
Select if each channel carries a separate soundtrack.
When the external audio is from the DV input, an audio subcode channel within the DV audio tells the recorder whether the audio is stereo or
bilingual. This has priority over the setting you make here.
Setting
Options Explanation
DVR-433H_UK.book 94 ページ 2005年3月1日 火曜日 午後5時6分